Kmart 42624141 User manual

Ite m N o .: 42624141

Ite m N a m e : 40CM STYLIN BIKE

Wheel Reector

Bag

Front Reector

Saddle

Streamer

Doll Seat

Quick Release

Seat Post

Brake Lever

Handle Bar

Front Brake

Cable Housing

Stem

Grip

Top Tube

Crank

Chain Guard

Chain

Training Wheel

Training Wheel Leg

Rear Reector

Tyre

Rim

Front Hub

Rear Hub

Pedal

Chain Wheel

Fork

Down Tube

5

Phillips head screwdriver;

adjustable wrench or an 8mm, 10mm, 13mm,14mm

15mm open and box end wrenches;Allen Keys;

A plier with cable cutting ability˗Air pump

Keep a Record of Your Bicycle

Each bicyle has a Serial Number stamped into the bottom of the frame. Write down this number to keep it for future reference.Take

a colour photograph of your bicycle, write the Serial number on the back of the photograph and keep it in a safe place. If you keep

arecord of the details of your bicycle it will greatly increase the possibility of getting it back should it be lost or stolen.

Remember the advice about LOCKING YOUR BICYCLE. A good quality lock is cheap insurance.

Tools required(Not included in the packing)

6” (15cm)

It is recommended that a torque wrench is used when

assembling the bike.

Tighten them so they do not move and are horizontal. Check the handlebar is in good condition and the ends of the

handlebar are plugged. Check the bell is fitted and working well.

Warning: Handlebar grips and tube end plugs should be replaced if damaged, as bare ends have been know to cause injury.

Please check the condition of grips and bar ends before rdie.

14

Brake installation

1. Attach the upper cable to the brake lever. Ensure that the

adjusting barrel is fully tightened in the brake lever.

2. Pull the link wire on the rear brake assembly until the brake

shoes are touching the rim wall and tighten the brake bolt.

3. Ensure that the brake shoes are positioned evenly with the

side surface of the rim.

Brake Cable

Installation

Attaching the Front Brake Cable

(For Bicycles equipped with a Front Brake)

1. Open the brake lever and place the barrel end of the cable

into the lever.

2. Feed brake cable through cable adjuster and through

anchor bolt. Secure anchor bolt firmly.

3. Fasten brake caliper to fork by sliding brake mount bolt

through center hole in fork. Secure brake mount bolt firmly.

4. Refer to the next section for Braking System Adjustment.

Brake and Cable

Adjustment

17

Page is loading ...

Kmart 42624141 User manual

Kmart 42624141 User manual

Related papers

Other documents