2. Home
  3. Home security & automation
  4. Security camera accessories
  5. Atdec
  6. TH-TVCB-CM

Atdec TH-TVCB-CM, Telehook TH-TVCB-CM Owner's manual

  • Hello! I've reviewed the installation instructions for the telehook Camera Shelf TH-TVCB CM. This document provides steps on how to install the camera shelf with adjustable pole and tray, ensuring a secure setup for your mobile cart. I'm ready to assist with any questions you may have about the installation process or the device itself.
  • What is the maximum load this product can support?
    What should be checked before installation?
    Can the tray be tightened?
1
2
180o
180o
360o
Installation Instructions
TH-TVCB-CM
Component Checklist
Camera Shelf Accessory for TH-TVCB Mobile Cart
HARDWARE
! IMPORTANT - Install Telehook Ceiling Mount as per installation instruction.
! This product supports a maximum load of 5kg (11lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the component checklist and hardware above.
Step 2. Step 3.
Step 4. Step 5.
Remove Cap
Lower the pole into
position
Lower the tray into position
and fasten it by turning the
handle Note that each joint
can be tightened
1x Tray Assembly
1x Adjustable Pole
Allen Key
6mm Allen Key
from TH-TVCB 2 x M6 Cap Screw
Ensure that the bolts are
aligned with the holes in
the sleeve and the pole
Remove existing bolts
using existing 6mm
allen key
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 14.04.13 ©
1
2
Step 5. Continued
Step 6.
Slide clip to release
25º
Lift the cap and use
the existing allen key
to tighten or loosen
the arm
/