2. WolfVision
  3. VZ-8neo+

WolfVision VZ-8neo+, VZ-3neo, VZ-8neo Operating instructions

  • Hello! I've reviewed the mounting instructions for the VZ-Xneo turnable and fixed mounts. This document details the process of aligning the swivel top plate using a template for both models. I am here to help you understand these steps and answer any questions you may have about the installation procedure.
  • How do I align the turnable mount?
    How do I align the fixed mount?
    What should I do after placing the template?
Turn swivel top plate to the
Move the template inclusive complete swivel until the bottom end and the center line of
this template matches the markings on the table top.
Tighten
end position in the opposite direction of desired closing down.
Place the cut-out of the template onto the swivel top plate.
the accessible screw, remove the template, turn the top plate of the swivel to
access the other screw and tighten it.
VZ-Xneo mounted turnable
center line
top border of max. camera pick-up area (4:3 mode)
Turn swivel top plate counter-clock-wise to the
Move the template inclusive complete swivel until the bottom end and the center line of
this template matches the markings on the table top.
Tighten
end position.
Place the cut-out of the template onto the swivel top plate.
the accessible screw, remove the template, turn the top plate of the swivel to
access the other screw and tighten it.
VZ-Xneo mounted fixed
center line
top border of max. camera pick-up area (4:3 mode)
/