Tripp Lite Isobar Direct Plug-In Surge Suppressors User manual

WARNING

DO NOT USE MOUNTING TAB AND SCREW IN CANADA.

CANADIAN REGULATIONS PROHIBIT PERMANENT

MOUNTING OF THE ISOBAR DIRECT PLUG-IN SURGE

SUPPRESSOR. USE OF THE MOUNTING TAB WILL

VOID ALL WARRANTIES AND INSURANCE OF THE

ISOBAR DIRECT PLUG-IN SURGE SUPPRESSOR.

If your local regulations allow permanent mounting, simply slide tab into slot on the top panel

of the surge suppressor. Adjust tab until it is flush with the rear of the surge suppressor. Secure

tab to surge suppressor with supplied screw. Secure surge suppressor to your receptacle’s cover

plate with cover plate screw.

CAUTION

To reduce the risk of electric shock, disconnect power to the receptacle before installing or

removing the Isobar. When removing receptacle’s cover plate screw, the cover plate may fall

across plug pins or receptacle may become dislodged.

is a registered trademark of Tripp Lite.

201112054 93-1239

MOUNTING TAB

A mounting tab and screw are enclosed for permanent mounting of your Isobar Direct Plug-In

Surge Suppressor. USE THIS TAB ONLY IF LOCAL REGULATIONS ALLOW

PERMANENT MOUNTING OF YOUR SURGE SUPPRESSOR.

ADDENDUM to Owner’s Manual #93-1153

Isobar

Ultra-Series

Direct Plug-In

Surge Suppressors

1111 W. 35th Street, Chicago, IL 60609 USA

www.tripplite.com/support

201112054 93-1239.indd 1 12/7/2011 2:56:31 PM

This manual is also suitable for

Download PDF