Touch T526S Installation guide

Category
Coffee making accessories
Type
Installation guide
QUICK SET-UP GUIDE
CARAFE READY T526S
NOTE:
Bottled or filtered water
is recommended.
A. SET-UP
Remove adhesive tapes.
Unwrap the Power Cord.
1
Remove the Water Tank by
tilting and lifting away from
the Brewer.
2
Rinse the Water Tank several
times. Fill with water.
3
Place the Water Tank and
Lid back on to the Brewer.
4
NOTE:
The first brewing cycle may take
up to 30 seconds to start.
WARNING:
DO NOT pull the Latch
while brewing.
Plug the Power Cord into
an electrical outlet.
Press the Power Button.
5
Place a large mug or cup
on the Drip Tray. (min. 12oz)
6
Press on the 10 oz Cup Size
Button to start brewing.
7
Discard the hot water and
repeat steps 6 and 7 at least
two (2) more times.
8
11
WARNING:
Coffee Pod may be HOT.
WARNING:
Sharp Needles on the Top Cover
and in the Red Cup Holder.
B-1. BREW
Place a mug on the Drip
Tray and lift the Cover by
pulling on the Latch.
9
Insert a coffee pod into
the Red Cup Holder.
Close the Cover.
10
Press the desired Cup Size Button to start brewing.
Enjoy your beverage!
XBold Cup
TM
for 8-14 oz Buttons.
XLarge Cup
TM
for 16-18 oz Buttons.
9
B-2. REFILL JUMBO CUP
Remove the Red Cup
Holder and Drip Tray.
10
Fill the Refill Jumbo Cup
with your own grind coffee
up to the rim.
Insert the Jumbo Refill
Cup into the Brewer.
Place the Carafe.
11
Press the Carafe Button to
start brewing.
Enjoy your beverage!
12
WARNING:
DO NOT overpack
with coffee.
WARNING:
Refill Jumbo Cup may
be HOT.
For Household Use Only
To learn more about Touch, visit www.touchbeverages.com or Call Toll-Free: 844-20TOUCH (844-208-6824)
© 2014 Touch, Incorporated All rights reserved
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Touch T526S Installation guide

Category
Coffee making accessories
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI