2) Press the Button ① to open the power then the indicator lamp ⑤ will be bright.
3) Adjust the Channel Selector ⑨ to the corresponding channel of monitor.
4) If the monitor is working, it will display the picture which camera was taken.
5) Adjust the Focus Adjustor ② to get the clearest image (when first time do it, then
afterward do not need to re-adjust it).
6) Place the camera in the far site, and synchronously adjust its antenna ⑦ and monitorˊs
to get the clearest image.
7) You can also adjust the direction and the up-angle of camera when you need.
TV Receiving
1) Use the pin of power supply line with adapter to insert into the DC jack ○
11
and, put the plug of
power supply line into the socket of power supply to connect the current. Press down the power
button ○
6
, there will appear the raster display on the screen. Press down the TV/Monitor Switch
Button ○
3
to the TV state, and press TV Band and Channel ○
4
to select the desired TV Band,
then the corresponding TV Band Indicator Lamp ○
8
will be bright. Pull out the Pull-shaft
Antenna ○
9
(or insert the extra antenna to the extension antenna jack ○
13
), turn the Turning
Knob ○
2
to the desired TV program, and then adjust the direction and length of Pull-shaft
Antenna ○
9
to get the clearest image and sound.