www.CasablancaFanCo.com
1.888.227.2178
M6008-01 • 04/17/14 • © Casablanca Fan Company
Model #99020
Remote Control
Transmitter
Installation
Installing or changing the battery -
To access the battery compartment
remove the small Phillips head
screw that secures the battery
door to the transmitter assembly.
Starting at one of the corners of
the door, pull upwards to remove
door. Replace with a CR2032 battery
when necessary. The battery should
be installed with the positive (+)
side up.
Phillips
Head
Screw
Battery
Door
Buttons one (1) through (4) turn on
the fan and control the speed.
(1) Extra Low
(2) Low
(3) Medium
(4) High
Pairing
Note: The remote must be paired
before the fan will operate.
Within 3 minutes of restoring
power to the fan, press both the
power button and the 4 button
for at least 3 seconds. The fan will
turn at the lowest speed signifying
that the remote pairing process is
complete. If using the transmitter
with multiple fans, repeat this
process for each fan.
Fan
Power
4
The up arrow and down arrow
buttons control the lights on the fan.
Quickly press the up or down arrow
to turn the lights off and on. Hold
the up or down arrow to raise or dim
the light level.
Up
Arrow
Down
Arrow
The power button found on the right
side of the transmitter turns the fan
off. The LED light will illuminate
when a button is pushed, letting you
know that the signal has been sent
to the fan.
Fan
Power
LED
Light
Operations
Your Universal Remote comes with
wall plates that have two (2) posts
on which to mount your transmitter
when not in use.
Post
Move the reverse switch to opposite
position to change the direction of
airow. The fan must be running to
use the reversing feature.
Reverse
Switch
OFF
Before pairing your remote, the
power must be turned off at the
breaker box. Wait 5 seconds and
then turn the power back on.
Read and Save These Instructions
If you are installing multiple remote-controlled fans
on the same circuit breaker,
you may need to perform a few extra steps to prevent
interference or faulty operation of your remote controls.
Go to www.HunterFan.com/FAQs and click “How do I properly
install multiple remote-controlled fans?” for more information.
www.CasablancaFanCo.com
1.888.227.2178
M6008-01 • 04/17/14 • © Casablanca Fan Company
TroubleshootingSafe-Exit
AUTHORIZED SERVICE CENTERS
For the most updated listing of Casablanca Authorized Service Centers,
visit www.CasablancaFanCo.com or call toll free 1-888-227-2178.
ONE YEAR WARRANTY
This product is warranted to the original purchaser by Casablanca Fan
Company against defects in material and workmanship for one (1) year
from date of purchase. During the warranty period, we will repair or, at
our option, replace a defective product at no charge. For information
on how to obtain service, contact Casablanca’s Service Department by
calling our toll-free number at 888-227-2178. Damage to the product
caused by mishandling, improper installation or modication is not
covered by this warranty. This warranty is given in lieu of all other
warranties expressed or implied. Some states do not allow limitations
of time on an implied warranty, therefore the above limitations may not
apply in every case. This warranty states specic legal rights which may
vary from state to state.
If you have problems installing or operating your fan, do not return this
product to the dealer. Call our Consumer Affairs Hotline.
888-227-2178
This device complies with RSS-210 of Industry Canada. Operation is subject
to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
1. This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
2. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures: Reorient or relocate the receiving antenna,
Increase the separation between the equipment and receiver, Connect the
equipment into an outlet on a circuit different from that to which the receiver
is connected. Consult the dealer or an experienced radio/TV technician for
help. Note: Any changes or modications to the transmitter or receiver not
expressly approved by Casablanca Fan Company may void one’s authority to
operate this remote control.
WARNINGS
Fan will not start
• Make sure the power is on at the circuit
breaker and the wall switch.
• Make sure the battery is working.
• Make sure that the transmitter and receiver
are paired.
• Check wire connections inside of the
canopy.
Remote control of fan is erratic
• Make sure the battery is installed correctly.
• Install a fresh battery.
The Safe-Exit Program gives you about thirty seconds of light
when you turn the lights off, to exit the room before the lights
go out. To use Safe-Exit.
• Press the fan power button off for at least three seconds to initiate
the Safe-Exit Mode.
• The lights will ash for visual conrmation.
• The lights will stay on 50% brightness for 20 seconds and then begin to
dim. After a total of 30 seconds, the lights will be completely off.
Note: For CFL lighting, the lights will stay on 100% brightness for 30
seconds. After a total of 30 seconds, the lights will be completely off.
Lights do not dim
• Check to see if a CFL bulb is installed. The
control has a feature that automatically
detects CFL bulbs and turns off dimming if a
CFL bulb is installed.
CFL bulbs icker
• Turn the light switch off and back on. Within
three minutes, hold down the Fan Off button
while pressing the Light button twice. If the
problem is not corrected, repeat the process
up to three times.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Casablanca 99020 Operating instructions
-
-
-
-
Casablanca Fan Company 54037 User manual
-
-
-
Casablanca M8502-01 User manual
-
Casablanca 59109 Owner's manual
-
Hunter Fan Stealth User manual
