Stonco WP Wall Pack Large LED Install Instructions
- Type
- Install Instructions
Part Number 443561204820 Rev. C
Page 1 of 1
© 2018 Signify Holding. All rights reserved. This document contains information relating to the product portfolio of
Signify which information may be subject to change. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability for any action in reliance thereon is
disclaimed. The information presented in this document is not intended as any commercial offer and does not form
part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.
Signify North America Corporation
200 Franklin Square Drive
Somerset N.J. 08873, USA
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Signify Classified - Internal
IMPORTANT: READ ALL INSTRUCTIONS BEFORE PERFORMING ANY WORK. BE SURE ALL
POWER IS OFF PRIOR TO INSTALLING LUMINAIRES.
INSTALLATION INSTRUCTIONS
LUMINAIRE WITH AUTOMATIC PROFILE DIMMING (APD)
WARNING: FIXTURE MUST BE GROUNDED IN ACCORDANCE WITH APPROPRIATE CODES.
FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY.
NOTE: THIS INSTALLATION INSTRUCTION SHEET IS FOR AUTOMATIC PROFILE DIMMING.
NOTE: APD WILL NOT ACTIVATE UNTIL THE THIRD NIGHT.
100
90
80
70
60
50
40
30
20
10
3 pm 5 pm 7 pm 9 pm 11 pm 1 am 3am 5 am 7am 9 am
FIGURE 1
-LUMINAIRE WITH APD IS A LAMP(S) CONTROL
DEVICE THAT ENABLES HIGH ENERGY
SAVINGS WITHOUT ANY INSTALLATION
EFFORT. INSTALL THE LUMINAIRE WITH THE
CORRECT LINE VOLTAGE AND WAIT FOR
THREE DAYS UNTIL THE DIMMING PROFILE IS
CALIBRATED.
-THE APD OPTION WORKS THROUGH A
SIGNIFY ADVANCE DEVICE CALLED THE
DYNADIMMER. IT IS A STAND-ALONE
LUMINAIRE BASED DEVICE WHICH CONTROLS
THE 1-10V LED DRIVER. ONCE THE
DYNADIMMER DETECTS ANY VOLTAGE IT
SWITCHES THE OUTPUT FROM 50%
STANDARD ILLUMINATION TO 100%.
-THE LUMINAIRE-APD HAS NO INTERNAL
CLOCK AND USES A NIGHT TIME MIDPOINT
CALCULATION TO DETERMINE THE ABSOLUTE
TIME. THE MIDPOINT IS CALCULATED AS THE
MIDDLE POINT BETWEEN THE “SWITCH ON”
POINT AND “SWITCH OFF” POINT.
-THE DYNADIMMER NEEDS TWO NIGHTS TO CHECK CONSISTENCY OF DURATION OF BOTH NIGHTS (ON/OFF
WITHIN 1 HOUR BOTH NIGHTS). THE DIMMING SCHEDULE WILL START TO OPERATE ON THE THIRD NIGHT AFTER
INSTALLATION.
-THE LUMINAIRE-APD IS PREPROGRAMMED AT THE FACTORY. THE PROGRAM DIMS THE LIGHT 50% 2 HOURS
BEFORE THE NIGHT TIME MIDPOINT AND 6 HOURS AFTER THE NIGHT TIME MIDPOINT (SEE FIGURE 1).
-
1
