Ibiza DJ350LED Owner's manual

1

D

I

S

C

O

S

O

U

N

D

S

E

T

DJ350LED (15-2014)

I

NSTRUCTION MANUAL

MANUEL D’UTILISATION

BEDIENUNGSANLEITUNG

HANDLEIDING

Imported from China by

LOTRONIC S.A.

Avenue Zénobe Gramme 9

B-1480 Saintes

2

IMPORTANT SAFETY INSTRUCTIONS

1) Read the manual prior to using this unit and keep it for future reference.

2) Adhere to all warnings and instructions marked on the unit and contained in the manual.

3) Don’t place the unit close to water, e.g. in a bathroom, near a wash tub, a swimming pool, etc.

4) The unit must match carriage and rack recommended by the manufacturer.

Sudden stops, great power and rough surface may cause combination turns over.

5) Keep away from heat sources such as radiator, stove and amplifier etc.

6) Operate the unit only with the rated power supply. Please ask your dealer or local power supply

company if you are not sure about your type of power supply .If the unit is operated with batteries or

other power supplies, please refer to this booklet.

7) Do not walk on or squeeze the power cord.

8) Clean this unit with a soft cloth. Prevent water and/or other liquids to enter into the housing.

9) Unplug the power cord if the unit is not used for a long time or during a thunderstorm to prevent

voltage surges to damage the inner circuitry.

10) Prevent objects and liquids to enter into unit.

11) If one of the following happens, refer to qualified service personnel:

A) Power cord or plug a damaged; or

B) An object or liquid has entered into the unit; or

C) The unit has been exposed to rain ; or

D) The unit doesn’t work; or

E) The unit has fallen or doesn’t work normally.

12) Repair ---Do not attempt to repair the unit yourself. All repairs must be carried out by a qualified

technician. The user is only allowed to perform manipulations, settings and controls specified in this

manual.

13) Ventilation --- Do not cover the ventilation openings to prevent overheating of the unit. Do not place

the unit on bed, blanket, sofa or similar soft surface. Do not place unit inside a bookcase, a closed

cupboard, etc.

14) Accessories---Not use parts that hare not recommended by the manufacturer in order to avoid

damage.

15) Auxiliary equipment ---Do not place this unit on unstable vehicle, shelf, tripod or table. It will cause

serious harm to child or adult if the unit falls down. Please use the vehicle, shelf, tripod or table

recommended by the manufacturer.

16) Spare parts---If the unit requires spare parts, use only spares recommended by the manufacturer and

that are in all aspects identical to the original parts. .

17) Safety check---After repairing, repairer must test the unit for security.

GB

3

MIXER

1. CH 1 Gain Control: Use this knob to adjust the gain of

LINE 1 input signal

2. CH 1 Treble Control: Use this knob to adjust the treble of

LINE 1 input signal

3. CH 1 Bass control: Use this knob to adjust the bass of the

LINE 1 input signal

4. MIC VOL: Use this knob to adjust the volume of the

microphone volume

5. USB Input: Connect the USB here

6. USB/Bluetooth & Line Selector: Press the selector to

switch the input between USB/Bluetooth and Line input.

7. CH 2 Gain Control: Use this knob to adjust the gain of

LINE 2 input signal

8. CH 2 Treble: Use this knob to adjust the treble of LINE 2

input signal

9. CH 2 Bass Control: Use this knob to adjust the bass of the

LINE 2 input signal

10. Headphone Vol: Use this knob to adjust the volume of headphone output

11. Master VOL: Use this knob to adjust the master volume

12. Line signal selector: Set the selector to the left side to mute the CH2 input signal and set the selector

to the right side to mute the CH 1 input signal. If the selector is in the middle position, both CH 1 input

signal & CH 2 input signal will be mixed and sent to OUTPUT Jacks.

REAR PANEL CONTROLS:

1. 12V Power supply: Connect the adapter

here

2. Master output: Connect this output to the

RCA input of an amplifier or active speaker

3. REC output: Connect this output to the RCA

input of a tape recorder, amplifier or active

speaker.

4. Line 2 input: Connect the Line 2 Signal here.

This is CH 2 signal.

5. Line 1 input: Connect the Line 1 signal here.

This is CH 1 signal.

CONTROLS

1. MIC input: Connect the microphone here

2. USB/Bluetooth Selector: Press this button

to switch the input between USB &

Bluetooth.

3. Play/Pause: Press this button to play the

4

signal from USB & Bluetooth. Press again to pause.

4. PREVIOUS: Press this button to go back to previous track on USB & Bluetooth signal.

5. Next: Press this button to go to next track on USB & Bluetooth.

6. Headphone output: Connect the headphone here

Bluetooth Connection:

To play Bluetooth signal, enable the Bluetooth function on a Bluetooth device like cell phone and set the

mixer to Bluetooth input mode and then search for available Bluetooth devices nearby on cell phone. The

Bluetooth name of the mixer is “DJ350LED”. Pair and connect. There is no pairing code.

Note: The DJ350LED is only discoverable when input is set to Bluetooth.

AMPLIFIER

1. Power: Press this button to power ON/OFF the unit.

2. L Volume: Use this knob to adjust the volume of left channel of main speaker output

3. R Volume: Use this knob to adjust the volume of right channel of main speaker output.

1. XLR Line input: Use the XLR connectors to connect to Line signal source to the XLR input of the amplifier.

2. RCA Line input: Use the RCA cables to connect the line signal source to the RCA line input of the amplifier.

3. 1/4” Line input: Use suitable jacks to connect the line signal source to the 1/4” line input of the amplifier.

4. SPEAKON OUTPUT: Connect the speakon outputs to the input of passive speakers.

5. MAIN Speakers output: Connect the main speaker outputs to the input of passive speakers.

Note: If there are four speakers connected to the speakon outputs and main speaker outputs, the impedance

of each speaker must be 8ohms at least to protect the amplifier.

6. Power Cord: Use the power cord provided with the amplifier to connect to the power outlet.

Electric products must not be put into household waste. Please bring them to a recycling centre. Ask

your local authorities or your dealer about the way to proceed.

Page is loading ...

EC Declaration of Conformity

Hereby we, LOTRONIC SA

Avenue Zénobe Gramme, 9

1480 SAINTES

Belgium

+32.2.390.91.91

Certify and declare under our sole responsibility that the following product:

Trade name: IBIZA SOUND

Product name: DJ KIT DISCO WITH 10’’LED SPEAKERS AND USB-BT MIXER

Type or model: DJ350LED

Conforms to the essential requirements of the:

LVD directive 2014/35/EU, RED directive 2014/53/EU and EMC directive 2014/30/EU

Based on the following specifications applied:

Safety : IEC 60065:2014

Health : EN62479 : 2010

EMC : EN301 489-1 V1.9.2 : 2011

EN301 489-17 V2.2.1 : 2012

EN55032 :2012 + AC :2013

EN55020 :2007 + A11 :2011

EN61000-3-2 :2014

EN61000-3-3 :2013

Radio : EN300 328 V1.9.1

Place and date of issue: Saintes (Belgium), on 01/09/2016

AKBAR Guive

Technical manager

Page is loading ...

Ibiza DJ350LED Owner's manual

This manual is also suitable for

Ibiza DJ350LED Owner's manual

in other languages

Related papers

Other documents