Bose 141 series1 Owner's manual

Brand: Bose

Model: 141 series1

Category: Loudspeakers

Type: Owner's manual

Bose

Model 141 Speakers

Owner’s Guide

October 30, 2001

AM182344_04_V.pdf

FPO

2 October 30, 2001 AM182344_04_V.pdf

For your records

Serial numbers are located on back of your Model 141 speakers.

Serial numbers:____________________________ and _______________________________

Dealer name:__________________________________________________________________

Dealer phone: _______________________ Purchase date: ___________________________

We recommend that you save your purchase receipt. It will be helpful if you ever need to

arrange for service.

Where to find…

Contents

Setting Up

Before you begin ........................................................................................................3

Unpack the carton......................................................................................................3

Select locations for your Model 141

speakers ...........................................................3

Connect the speakers ................................................................................................4

Choose the cord..................................................................................................4

Prepare the cord .................................................................................................4

Make the connections.........................................................................................4

Check the connections .......................................................................................5

Test the speakers................................................................................................5

Maintaining Your Speakers

To clean your Model 141 speakers ............................................................................6

Troubleshooting..........................................................................................................6

Product Information

Warranty period..........................................................................................................7

Technical information .................................................................................................7

Bose

Corporation ................................................................................. inside back cover

Dansk

Deutsch

Español

Français

Italiano

Nederlands

Svenska

AM182344_04_V.pdf October 30, 2001 3

Before you begin

Thank you for choosing Bose

Model 141 speakers. Their advanced design and quality

construction are meant to provide high-quality listening enjoyment in your home.

The StarDriver

4.5-inch full-range driver inside each speaker delivers performance usually

associated with much larger, more costly speakers.

Please read this owner’s guide. It will help you set up and use the speakers properly, so they

can deliver the finest sound for your listening pleasure.

Note:

These speakers are not designed for use outdoors or in automobiles.

Unpack the carton

Carefully unpack the carton. Save all packing materials for possible future use. Carefully

peel the clear protective plastic strip from each speaker’s metallic accent panel.

Inspect the speakers. If either speaker appears damaged, do not use them. Instead, repack

both speakers in the original carton and notify your authorized Bose dealer immediately.

Note:

Now is a good time to record your speakers’ serial numbers. Write them in at the

beginning of this guide and on your warranty card.

Select locations for your Model 141 speakers

Your Model 141 speakers are designed to provide full stereo performance while taking up

very little space. You can easily fit them on a shelf or table, either horizontally or standing on

end.

For best performance:

• Place the speakers at least 5 feet (1.5 m) apart.

• Position them within 18 inches (45 cm) of the wall behind them.

• Avoid placing them exactly halfway between the floor and ceiling.

• To prevent video interference, keep them at least 2 feet (61 cm) from any video screen.

Note:

Set the speakers only on surfaces that are stable and level. For some surfaces, you

may want to use rubber feet for additional stability. To request them free of charge, contact

Bose Service (see the inside back cover) or your local Bose Service agency and ask for

Part Number 178321.

Right speaker

Figure 1

Your Model 141 speakers

Left speaker

CAUTION:

To avoid danger of suffocation,

keep the plastic bags that

wrap these speakers out of the

reach of children.

Setting Up

4 October 30, 2001 AM182344_04_V.pdf

Setting Up

CAUTION:

Before making any connec-

tions, turn off your receiver or

amplifier and unplug it from

the outlet (AC power mains).

Not doing so may result in

damage to your system.

Figure 2

How to make terminal connec-

tions

Connect the speakers

Position the opening on the front of each speaker (its port) toward the side wall of your

room. Or set speakers port side down if you position them vertically. As you face the

speakers, the speaker placed on your right will connect to the RIGHT SPEAKER channel of

your amplifier or receiver.

Choose the cord

It is important to use the proper gauge (thickness) of speaker cord. Standard zip cord

(2-conductor, 18-gauge stranded wire) works for most applications. You can find this wire

at most electrical and hardware stores.

You will need thicker wire if your speakers will be more than 30 feet from a receiver or

amplifier. Refer to the wire recommendations under “Technical information” on page 7, or

contact your authorized Bose

dealer for more information.

Note:

Before running speaker cord through a wall or under a floor, check your local

building code requirements and safety regulations. You may want to contact an electrical

installer for this information.

Prepare the cord

Speaker cord consists of two insulated wires. The insulation around one wire is marked

(striped, collared, or ribbed). This marked wire is always positive (+). The plain wire is always

negative (–). These wires correspond to the red (+) and black (–) terminals on the speakers

and the receiver or amplifier.

At the ends of each cord, strip approximately

⁄

-inch (12 mm) of insulation from both wires.

Twist the bare end of each wire, so loose strands will not touch across terminals. Be sure to

connect each wire to the proper terminal (positive to positive and negative to negative).

Note:

It is sometimes difficult to distinguish wire markings. Inspect both wires carefully.

Make the connections

Just press down the terminal tab on the back of each speaker to insert the appropriate wire

(Figure 2).

1. Connect one speaker cord to your right speaker.

a. Attach the marked wire to the red (+) terminal.

b. Attach the plain wire to the black (–) terminal.

2. Connect the other end of the same cord to the RIGHT SPEAKER OUTPUT of your

receiver or amplifier.

a. Attach the marked wire to the red (+) terminal.

b. Attach the plain wire to the black (–) terminal.

3. Connect the second cord to the left speaker and LEFT SPEAKER OUTPUT. Follow the

procedure described above.

CAUTION:

Never use broken or frayed

wires, which can result in

electrical shock or damage.

red

marked

wire

AM182344_04_V.pdf October 30, 2001 5

– ++–

Setting Up

Test the speakers

To make sure your speakers operate correctly:

1. Set your receiver or amplifier to MONO (monophonic) and turn it on.

2. Set the balance control to normal (center position).

3. Place the speakers less than 6 inches (15 cm) apart, facing each other.

4. Play some deep bass passages of music through the speaker.

The sound should seem to come from a point between the two speakers. The bass should

be full and natural. If it is not, your connections may be out of phase. To make them match

connections to the amplifier, try reversing the + and – connections on the back of one

speaker. Then repeat steps 1 – 4.

Figure 3

Completed connections

Check the connections

Check to be sure all connections are made positive to positive (+ to +) and negative to

negative (– to –). Make sure that no loose strands of wire touch across terminals. Bridged

wires can short circuit and damage the speaker components. Tighten any loose connec-

tions before you plug in the receiver or amplifier and turn it on.

–

Amplifier or receiver

6 October 30, 2001 AM182344_04_V.pdf

Maintaining Your Speakers

Problem Possible cause How to find out Solution

To clean your Model 141

speakers

Wipe the Model 141 speaker cabinets clean using a soft cloth dampened with a mild

detergent. Do not allow liquids to spill into the speaker grilles.

No other regular maintenance is required.

Troubleshooting

If you have a problem with your Model 141 speakers:

1. Turn off your amplifier or receiver and check all connections between the speakers and

the amplifier or receiver.

2. Check your amplifier or receiver owner’s guide. That component may be the source of

the problem.

3. Use the troubleshooting guidelines below. If they do not solve your problem, contact

your Bose

dealer to arrange for service. Or, to contact Bose directly, refer to the listing

on the inside back cover of this guide. Bose Corporation will make every effort to

remedy any problem within the terms of your warranty.

Defective speaker or

malfunctioning receiver

or amplifier channel.

Both speakers do not

play or sound distorted.

Defective speaker cord.

One speaker doesn’t play

or sounds defective.

Switch the speaker cords

at both ends. Connect the

right speaker cord to the

left speaker and to the left

speaker channel of the

amplifier or receiver.

Connect the left speaker

cord to the other speaker

and amplifier channel.

If the originally faulty speaker

now plays properly and the

other does not, the cord on

the malfunctioning speaker

is defective.

If the originally faulty speaker

still does not play properly,

the speaker is probably

defective. Call Bose or your

retailer to arrange for service.

If the originally faulty speaker

now plays, one channel in

the amplifier or receiver is

probably defective. Try

another receiver.

Switch the cords at the

speaker end only.

Reconnect the speakers to

another amplifier or receiver

that is working properly.

Defective amplifier

or receiver.

AM182344_04_V.pdf October 30, 2001 7

Product Information

Warranty period

Bose

Model 141 speakers are covered by a limited 5-year transferable warranty. Details of

the coverage are provided on the warranty card that came with your speakers. Please fill out

the information section on your card, detach, and mail to Bose.

Technical information

Quality standard

Syncom

computer quality control

Driver complement

One StarDriver

full-range driver per speaker

Compatibility/Impedance

Compatible with amplifiers and receivers rated 10 to 80 watts per channel; rated 4-8 ohms

Wire recommendations

Based on a maximum frequency response deviation of ±0.5 dB.

Gauge Length

18 (0.75 mm

) 30 ft (9 m) maximum

16 (1.5 mm

) 45 ft (14 m) maximum

14 (2.0 mm

) 70 ft (21 m) maximum

Enclosure

Slate gray vinyl veneer

Cloth-covered molded plastic grilles

Size/Weight

Each speaker: 6"H x 9

⁄

"W x 6

⁄

"D (15.2 x 24.8 x 16.5 cm)

Each speaker: 4.4 lb (2 kg)

Speaker pair in shipping carton: 11 lb (5 kg)

8 October 30, 2001 AM182344_04_V.pdf

AM182344_04_V.pdf October 30, 2001 9

Bose

Corporation

USA

Bose Corporation, The Mountain

Framingham, MA 01701-9168

1-800-367-4008

Phone hours - ET (eastern time):

Weekdays 8:30 a.m. to 8 p.m.

Saturdays 9 a.m. to 3 p.m.

Canada

Bose Ltd., 1-35 East Beaver Creek Road

Richmond Hill, Ontario L4B 1B3

1-800-465-2673

Phone hours - ET (eastern time):

Weekdays 9 a.m. to 5 p.m.

European Office

Bose B.V., Nijverheidstraat 8

1135 GE Edam, Nederland

TEL 0299-390111 FAX 0299-390114

Australia

Bose Australia, Inc., 1 Sorrell Street

Parramatta, N.S.W. 2150

TEL 02 204-6111 FAX 02 204-6122

Belgique/België

Bose N.V., Limesweg 2, B-3700 Tongeren

TEL 012-390800 FAX 012-390840

Danmark

Bose A/S, Industrivej 7, 2605 Brøndby

TEL 4343-7777 FAX 4343-7818

Deutschland

Bose GmbH, Max-Planck-Straße 36d

D-61381 Friedrichsdorf

TEL 06172-71040 FAX 06172-710419

France

Bose S.A., 6, rue Saint Vincent

78100 Saint Germain en Laye

TEL 01-30616363 FAX 01-30614105

India

Bose Corporation India Private Limited

W-16, Greater Kailash-II

New Delhi 110 048

TEL (011) 648 4462 FAX (011) 648 4463

Ireland

Bose Corporation

Carrickmacross, Co Monaghan

TEL 042-9661988 FAX 042-9661998

Italia

Bose S.p.A., Via della Magliana 876

00148 Roma

TEL 06-65670802 FAX 06-65680167

Japan

Bose K.K., Shibuya YT Building

28-3 Maruyama-cho

Shibuya-ku, Tokyo 150

TEL 3-5489-0955 FAX 3-5489-0592

Nederland

Bose B.V., Nijverheidstraat 8

1135 GE Edam

TEL 0299-390111 FAX 0299-390109

Norge

Bose A/S, Solheimsgate 11

N-2001, Lillestrøm

TEL 63-817380 FAX 63-810819

Österreich

Bose Ges.m.b.H., Vienna Business Park

Wienerbergstrasse 7 (10.OG)

A-1100 Vienna

TEL 01-60404340 FAX 01-604043423

Schweiz

Bose AG, Rünenbergerstrasse 13

4460-Gelterkinden

TEL 061-9815544 FAX 061-9815502

Sverige

Bose A/S, Johannefredsgatan 4

S-43153 Mölndal

TEL 31-878850 FAX 31-274891

United Kingdom

Bose Limited

1 Ambley Green

Gillingham Business Park

Gillingham, Kent ME8 0NJ

TEL 0870-741-4500 FAX 0870-741-4545

From other locations

Bose Customer Service, 1 New York Ave.

Framingham, MA 01701-9168 USA

TEL (508) 766-1900 FAX (508) 766-1919

World Wide Web

www.bose.com

10 October 30, 2001 AM182344_04_V.pdf

Framingham, MA 01701-9168 USA

JN94954 PN182344 Rev.04 AM182344 Rev.04

Bose 141 series1 Owner's manual

Brand: Bose

Model: 141 series1

Category: Loudspeakers

Type: Owner's manual

Download PDF

report

Bose 141 series1 Owner's manual

Bose 141 series1 Owner's manual

Related papers

Other documents