iStarUSA TC-RAIL-26 Installation guide

INSTALLATION MANUAL

Ball bearing sliding rails build from same SECC steel with length of

20, 24, and 26. The rail is built to last and can hold system weight up

to 85 lbs. Easy maintenance to slide system in and out of cabinet.

Package Contents

Copy right

ma y be reprod uced , transmitted, tran scribed, stored in a retrieval sy stem, transl ated

in to any language, in any f orm or by an mea ns or otherwise, with out t he prior wri tten

pe rmission of I -Star USA In c. 7 27 P hillips Dr., City of Industry, CA 91748.

iS tarUSA In c. reserve s the right to make mod ification and additi on

s to this product an d

ma nual with out notice or tak ing any liability.

iS tarUSA Inc. assum es no liability for errors or omission s i n t his document. Nor do se

iS tarUSA In c. make any c ommitment to upd ate th e info rmat ion co ntained he rein.

Pi ctures in th is docum ent are for de mons tration purp ose o nly and m ay not b e the same

as the actual p rodu ct.

Disc laimer

TC-Rail Series

Installation

(Pull the center slide all the way out until it reaches the end)

You will see a locking clip at the end point of the center slide.

Push it down and unlock the center slide.

Now put the center slide right next to the rackmount chassis. You should be able to find

screw holdes on both sides of chassis. Holes are used for mounting the center slide.

Later, the center slide will be use for attaching the sliding rail.

Secure outter rail to L bracket with

screws and nuts.

Aline front outter rail to the indent of L bracket between Point A & B.

Reattach inner rail back to center rail

Repeat previous steps to secure

sliding rails on both sides.