Owens Corning
™
Aluminum and Vinyl Garage Door
Bottom Seal
Product Data Sheet
Description
Owens Corning
™
Aluminum
and Vinyl Garage Door Bottom
Weatherstrip is designed to
help keep your garage clean and
more comfortable by forming a
weathertight seal to help protect
against drafts, dust, moisture,
debris and insects all season long.
A low temperature vinyl seal
closes gaps up to ¾ " at the
bottom of garage door and
stays exible to -30°F. The vinyl
seal insert is held in place with
a sturdy aluminum extrusion
fastened to the bottom of the
garage door with included screws.
Recommended for both wood
and metal garage doors.
Comes in two sizes: 9' for a single
car garage and 18' for a two car
garage.
Features
Contents
9' Aluminum and Vinyl Garage
Door Bottom Seal
• Two—54" long Aluminum
Channels
• One—9' (108") long Vinyl Seal
• Color—Extrusion: Silver; Vinyl
Seal: Black
• Ten—¾" long ¼" Hex head
self-drilling screws
18' Aluminum and Vinyl Garage
Door Bottom Seal
• Four—54" long Aluminum
Channels
• One—18' (216") long Vinyl Seal
• Color—Extrusion: Silver; Vinyl
Seal: Black
• Twenty—¾" long ¼" Hex head
self-drilling screws
Bene ts
• Helps to keep out drafts, wind
driven rain and snow, dust, dirt
and leaves, insects and rodents
• Sturdy aluminum extrusion
• Seal closes gaps up to ¾ "
• Durable vinyl seal stays exible
to -30°F
• Easy to install
Recommended Tools
1. Safety Glasses
2. Measuring tape
3. Hacksaw or jigsaw with blade
for cutting aluminum
4. Drill and ¼" driver bit or hex
head socket wrench/hex driver
5. Scissors or cutting knife
6. Pencil
Installation Instructions
• Remove old seal from
garage door.
• Measure underside of garage
door and cut aluminum base
and vinyl seal to correct length.
• Center the aluminum base on
the garage door bottom and
fasten into position with self-
drilling screws.
• Slide vinyl seal into
aluminum channels.
• Trim to length.
• Crimp Aluminum channel
to hold seal in place.
• Added Note: For garage doors
with guide rails: Slide one edge
of vinyl into position before
fastening aluminum base. Once
fastened, insert inside ange of
opposite rubber edge, and push
outside ange into channel with
screwdriver. Begin at either end
of aluminum base.
Safety and Precautions
WARNING:
CHOKING HAZARD.
KEEP OUT OF REACH OF
CHILDREN.
Disclaimer of Liability
Technical information contained herein is furnished
without charge or obligation and is given and accepted
at recipient’s sole risk. Because conditions of use may
vary and are beyond our control, Owens Corning makes
no representation about, and is not responsible or
liable for the accuracy or reliability of data associated
with particular uses of any product described herein.
Nothing contained in this bulletin shall be considered a
recommendation.
OWENS CORNING INSULATING SYSTEMS, LLC
ONE OWENS CORNING PARKWAY
TOLEDO, OHIO, USA 43659
1
-
800
-
GET
-
PINK
®
ww w.owenscorning.com
Pub. No. 10013876. Printed in U.S.A. July 2011. THE PINK PANTHER
™
& ©1964–2011 Metro-Goldwyn-Mayer Studios Inc. All Rights
Reserved. The color PINK is a registered trademark of Owens Corning.
©2011 Owens Corning.
• Helps form a weathertight seal against garage floor
• Vinyl seal stays flexible in low temperatures
• Recommended for single wood and metal doors
Helps keep out drafts, dust, leaves and moisture.
• Ayuda a formar un sellado hermético contra el piso del garaje
• El sello vinílico es flexible aún en bajas temperaturas
Mejora la protección contra corrientes de aire, polvo, hojas y humedad.
ALUMINUM AND VINYL
GARAGE DOOR BOTTOM SEAL
SELLO VINÍLICO Y DE ALUMINIO PARA
LA PARTE INFERIOR DE LA PUERTA DE GARAGE
• Recomendado para puertas de madera y metal simples
• Two 54 in. aluminum channels (9 ft.)
• One 9 ft. vinyl seal
• 10 Hexhead self-drilling screws
• Dos canales de aluminio de 54 pulg. (9 pies)
• Un sello vinílico de 9 pies
• 10 tornillos autorroscantes de cabeza hexagonal
Sistema de eficiencia energética
Includes:
Incluye:
™
Energy Efficiency
System
Seals gaps up to 3/4 in. high at bottom of standard single car garage door.
Sella aberturas de hasta 3/4 pulg. en la parte inferior de las puertas estándar de garaje simples.
o
stand
Seals
aps up to 3/4 in