User Manual
90cm Glass Under Cupboard
Rangehood
UCG90B & UCG90W
Dear Customer,
We thank you for choosing this quality appliance and hope you enjoy many
years of reliable service.
Please ensure this manual is read carefully before installation and use.
Keep this manual in a safe and accessible location should future reference
be required.
Regards
Home Appliances
CONTENT
1 …………………………………………………. Notice
2 …………………………………………………. Safety Warning
3 …………………………………………………. Function & Feature
4 …………………………………………………. Installation
5 ……..………………………………………….. Operation
6 ……………………………………………..….. Maintenance
7 …………………………………………..…… Abnormity and Solution
8 …………………………………………..…… Ducting Kit Solutions
1
NOTICE
1. Thank you for choosing our canopy rangehood.
Please read the instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and competent
installer.
3. The manufacturer disclaims all liability for any damage or injury caused as
a result of not following instructions for installation contained in the following
text.
The power rating used for this Rangehood is 220/240v, 50Hz.
2
SAFETY WARNINGS
• Install
ation of this Integrated Canopy Rangehood must be carried by
a
Qualified and competent installer electrician. Before you use the Rangehood,
make sure that the voltage (V) and the frequency (Hz) indicat
ed on the
Rangehoo
d are exactly the same as the voltage (V) and the frequenc
y (Hz)
in y
our home
.
• HA
PL will not bear any responsibility for the damage or injury caused as
a
result of
not following this instruction manual or by inappropriate installati
on
an
d us
age.
• T
his Integrated Rangehood is not intended for use by young children or
infirm persons without supervision. Young children should not play with th
is
Integrated Rangehood. Please ensure children supervised when near the
Rangehood.
• To avoid
possible electric shock this Integrated Rangeho
od should be
unplugged before
any maintenance or cleaning is carried
out.
• Thi
s Integrated Rangehood cannot be installed in an exte
rnal
envi
ronment, and it is not recommended for use over
Barbeques.
• The
Grease Filters should be cleaned at least once a month to avoid
the
risk of fire.
• Fl
ambé cooking cannot be carri
ed out under the Integrated
Ra
ngehood.
• Ducting
must be independent from any other form of ducting of
other
Household heating sources.
Ducting into wall cavities is prohibited unless
the cavity has been designed for this
purpose.
• A
gas burner that has been ignited should never remain uncovered or on
when there is no pan present du
e to the risk of fire.
• Adequate ventilation of the room is required when the cooker hood is used
at the
same time as appliances that use gas or other fue
ls.
- CAUTION
: Accessible parts may become hot when used
with cooking
appli
a
nces.
3
FUNCTION AND FEATURE
1. The cooker hood is made of high quality materials with streamlined
design accordingly to technical and physical engineering theory, high
end and luxury with age aesthetic feeling, also there are kinds of styles
for your option to perfect your kitchen.
2. The Rangehood quipped with a large power low noise electric motor
and centrifugal fan, it produces strong extraction, low noise, non-stick
grease filter and is easy to clean.
3. The grease filter is easy to remove and clean in warm soapy water. The
motor and other internal parts should only be wiped lightly with a paper
towel or damp cloth. Please ensure the power is turned off when cleaning
to avoid any injury.
4
1. INSTALLATION
1) The rangehood should be installed at the recommended
distance of 650-750mm from the cooking surface for the
best effect.
The recommended minimum distance between the lowest
point of the rangehood and the cooking surface of the hob
is – 65cm minimum, when located above a gas appliance
hob and 60cm minimum, when located above an electric
hob.
2) Measure and cut a hole in the cabinet, with a width of 500x275mm (UCG52) and
880x275mm (UCG90), and then centre above the cooktop. Ensure the distance
between the edges of the cut-out to the edge of the cupboard is at least 35mm.
3) Place the hood into the cabinet, and tighten up the screws with a screwdriver, and
make sure the hood is fixed securely.
4) Once the rangehood is installed, we recommend that the appropriate Ducting Kit for
the installation should be used for the best results. Please
Pic 2
Warning: Failure to install the screws or fixing the rangehood in accordance with
these instructions may result in electrical hazards
5
2. OPERATION
LED
Touch control has four buttons:
(Timer), (Lamp), (Speed)
(Power). See Pic
1. Power on: After you have connected the rangehood to the mains supply,
the
backlight of button will turn on. The backlight will turn off after 30 seconds if no
operation has been detected, and the rangehood will enter into stand-by mode
.
2. Pr
es
s
button once, lights will be on. Press button again; lights will be off.
3. Turn on hood and select the speed, use button “
”, the motor works at 3 speeds,
low, mid and high, and the LED display will display “1”, “2”, “3”.
Press
once, the motor starts to work at low speed and the LED display will
display “1”,
Press
again base on the low speed, the motor works at mid speed and the LED
display will display “2”,
Press
again base on the mid speed, the motor works at high speed and the
LED display will display “3”.
Go on pressing
button, the hood works at low speed again and it repeats:
“low→mid→high→low→mid…”
4. Pres
s
button once, the hood will work at the speed which it was on last use.
Pres
s
button again, the hood will stop working.
5. The time button
will work only when the motor is working.
Press
, the rangehood enters into timer setting mode. The max delay time is 9
minutes, and the LED display will display “9”.
When the timer is set, the LED display will display “9”,”8”,”7”…….decreasing by every
minute, when it displays “1”, the motor will continue working for 60s and then stop.
Press
once, the rangehood will enter into the timer setting mode, press
6
once again, the rangehood will exit the timer setting mode. Press once
when the cooker hood is working at timer setting, the cooker hood will exit the timer
setting mode automatically.
3. MAINTENA
NCE
1) The r
angehood and its filters should be cleaned regularly in order to keep them in
good working order. Because the grease filters are made of metal, do not clean the
filters with corrosive detergents that damage metal products
.
Clean the f
ilters as below:
a)
Method one:
Put the f
ilter in the water (40 - 50℃), pour in some grease-loosening detergent, soak it
for about 2-3 minutes and then clean it with a soft brush. Do not brush too hard so
as
not t
o damage the filter
.
2) T
o protect the main body from corrosion over a long period of time, the ra
ngehood
should be c
leaned with warm soapy water or non-corrosive detergent once a week.
Do not use grinding detergent, or it will damage the body
.
3) K
eep the motor and other spare parts free from water, as this will cause damage to
the appliance.
4) The replacement of the LED light should only be carried out by a qualified technician.
5) Disassembly and assembly the filt
er:
7
4 . ABNORMITY AND SOLUTION
Fault Cause Solution
Light does
not work, but
motor work
The bulb damaged Change bulb
Bulb contact lamp cap bad Fix or change
Light panel switch damage Fix or change
Light w
ork, but motor does
not work
Bulb contact lamp cap Restart later
Motor bearings damage
Motor burn out
Motor control switch damage
Light does not work, motor
does not work
Plug contact outlet bad
plug i
n correctly
Power wire cut
Switch damage
Shake of the body
Motor screw loosen
Combination screw loosen
Insufficient suction
The distance between the body
and the gas top too long
Re-adjust the distance
Cross-ventilation too strong or too
closed in the kitchen
Reduce
cross-ventilation or
open the window
Exhaust pipe too long
Adjust the length of
pipe
Air outlet valve not open
Check the valve if
operating cor
rectly
The outside breeze is too strong
No the technical
problem
contact a service agent
contact a service agent
contact a service agent
contact a service agent
contact a service agent
Fan motor damaged
service call
service call
service call
Hood body not secure
Secure the
hood body
8
5 . DUCTING KIT SOLUTIONS
Wall Ducting Kit
Eave Ducting Kit
Metal Roof Ducting KitTile Roof Ducting Kit
*For customer service please contact us on: 1800 805 300 or
Distributed by:
Home Appliances Pty. Ltd.
20 Carlotta Street, Artarmon NSW 2064
Tel: 02 9958 3111 Fax: 02 9958 3555
Email: [email protected]
Website: www.hapl.com.au
/