King Canada SS-1620CLM User manual

Brand: King Canada

Model: SS-1620CLM

Type: User manual

MODEL: SS-1620CLM

CANADA TOOLS INC.

STAND

PROOF OF PURCHASE

Please keep your dated proof of purchase for warranty and servicing purposes.

LIMITED TOOL WARRANTY

King Canada makes every effort to ensure that this product meets high quality and

durability standards. King Canada warrants to the original retail consumer a 2-year

limited warranty as of the date the product was purchased at retail and that each

product is free from defects in materials. Warranty does not apply to defects due

directly or indirectly to misuse, abuse, normal wear and tear, negligence or acci-

dents, repairs done by an unauthorized service centre, alterations and lack of main-

tenance. King Canada shall in no event be liable for death, injuries to persons or

property or for incidental, special or consequential damages arising from the use of

our products.

To take advantage of this limited warranty, return the product at your expense

together with your dated proof of purshase to an authorized King Canada service

centre. Contact your retailer or visit our web site at www.kingcanada.com for an

updated listing of our authorized service centres. In cooperation with our authorized

serviced centre, King Canada will either repair or replace the product if any part or

parts covered under this warranty which examination proves to be defective in

workmanship or material during the warranty period.

NOTE TO USER

This instruction manual is meant to serve as a guide only. Specifications and

references are subject to change without prior notice.

ASSEMBLY

WARNING! TO REDUCE THE POTENTIAL FOR PERSONAL

INJURY AND/OR DAMAGE, BEFORE ASSEMBLING MACHINE ON

STAND, MAKE SURE THE MACHINE IS TURNED OFF. DO NOT

TURN ON THE MACHINE UNTIL AFTER THE ASSEMBLY STEPS

HAVE BEEN COMPLETED.

This stand is designed to install King 16” x 20” Lathe/Mill model

KC-1620CLM.

1. Transport machine using lifting equipment such as a fork lift, hoist

or crane. Holes (A) Fig.1 are provided at each end of the bed,

insert 3/4” steel bars through these holes and use lifting straps to

lift, as shown in Fig.1.

2. Install the stand brackets (A) Fig.2 underneath the machine as

shown using 2 hex. bolts and washers for each bracket. The hex.

bolts and washers get installed from underneath the stand

bracket. Once this is done lower the machine onto the stand and

secure stand brackets (A) to the stand using 4 hex. bolts and

washers (B).

3. Install the 4 balancing supports (C) Fig.2 to each bottom corner of

the stand using 3 pan head screws (D). These supports are made

to bolt the machine to the floor or to help level the stand if the floor

is uneven.

FIGURE 1

FIGURE 2

King Canada SS-1620CLM User manual

King Canada SS-1620CLM User manual

King Canada SS-1620CLM User manual

Related papers