Setting up the car mount
1 Open the stand locks.
2 Lift the headrest on the front seat.
3 Rotate the brackets to an angle that will allow the brackets t through
the headrest posts.
RF-CARMNT2
I
iPad 2 Car Mount
Quick Setup Guide
General description
Congratulations on your purchase of the iPad 2 car mount. The iPad car
mount securely holds your iPad 2 for use or display.
Package contents
4 Slide the brackets through the headrest posts.
5 Close the stand’s locks.
6 Close the stand locks.
7 Put your iPad 2 into the sleeve by placing
the bottom of your iPad 2 into the
bottom of the sleeve, then
pressing the top of your iPad 2
into the sleeve.
Sleeve Stand with base pre-installed
acket
o
a
a
a
e bra
s
h
h
8 While pressing the latches on the stand, slide the sleeve into the stand.
9 The stand rotates for 90° viewing your iPad 2 vertically or horizontally.
Caution: Be very careful and make sure the sleeve is securely mounted
to the stand before releasing it.
To release the sleeve:
• While pressing the latches on the stand, pull the sleeve away from the
stand.
Caution: Be very careful and make sure the sleeve is securely mounted to
the stand before releasing it.
ENGLISH 11-0499
Cable management:
• Plug the charging cable into the 30-pin slot. Clips also help to hold
charging cable and headphone cables in place while on the move.
One-year limited warranty
Visit www.rocketshproducts.com for details.
Contact Rocketsh:
For customer service please call 1-800-620-2790
www.rocketshproducts.com
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richeld, Minnesota, 55423-3645 USA
© 2011 BBY Solutions, Inc. All rights reserved. ROCKETFISH is a trademark of BBY
Solutions, Inc. All other products and brand names are trademarks of their
respective owners.
30pin
s
s
s
s in
e 30-
es
the
i
in p
n pla
lace
o
ace w
also h
n the
move
move
move.
o the 30
les
ables
able
one cable
able
one cable
one cabl
i
30
les
o the 30
es i
o the 30-
es i
s
o
slo
30pin
/
