2. Home
  3. Domestic appliances
  4. Climate control
  5. Fireplaces
  6. HY-C
  7. FB1515U

HY-C FB1515U, FB2020U, FB2424U, FB2727U Installation guide

  • Hello! I am an AI chatbot trained to assist you with the HY-C FB1515U Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
FIREBACK INSTRUCTION SHEET
• FB1515 • FB1515U • FB1618 • FB1618U • FB2020 • FB2020U • FB2424 • FB2424U • FB2727 • FB2727U •
FBINST 05-2019
Firebacks protect the walls of the heat chamber in a replace from premature cracking and degradaon. They also boost a replace’s heat output by
deecng a majority of the re’s heat back into the room. Our unnished stainless steel models [FB1515U, FB1618U, FB2020U, FB2424U, FB2727U]
will deect more heat than our painted models. The nish on our painted models may deteriorate aer use.
Installaon Consideraons:
• No tools are required for this installaon.
• All work must be performed aer the re is exnguished and all coals/ashes are cold.
• All coals/ashes should be stored or disposed of properly.
• Please remove the support brackets/feet from the box before discarding any packaging.
• The nish on painted rebacks may peel or crack due to extreme heat. Painted rebacks
may be cleaned, lightly sanded, and re-painted with a high temperature paint.
FB2424 | FB2424U FIREBACK SUPPORT BRACKETS/LEGS
STEP 1
Remove all exisng equipment from the replace, including grates, andirons, and/or gas logs. Clean the
rebox by properly storing or disposing of all coals/ashes.
STEP 2
Inspect the rebox for severe cracks, voids, or refractory failure and if necessary contact a professional to
repair any exisng damage.
STEP 3
Place the support brackets/feet [included in the reback packaging] into the base of the replace and posion
the reback into the same slot on both brackets. The slots in the brackets allow for a slight forward-leaning,
straight upright, or a slight rear-leaning stance. Select the desired posion to maximize heat output. Center
the reback right to le in the rebox and approximately 1” from the back wall. It may be necessary to rotate
the brackets to select the desired posion. [Oponal Installaon Method: center the reback right to le in
the rebox and then lean it against the rear wall of the rebox.]
STEP 4
Re-install andirons, grates, and other equipment removed in Step 1.
10950 Linpage Place St. Louis, MO 63132 www.hy-c.com 800-325-7076 sales@hy-c.com
/