SECUR360 3003897 User manual

Download the SECUR360 App

• Go to the App Store

and search for the “SECUR360” app or Google Play™ and search for

“HeathZenith” and download the SECUR360 app.

• If you already have a SECUR360 account, skip to step 3.

Create a SECUR360 Account

• On your mobile device, open the SECUR360 app and press the “Register” button to create a new

account.

• Type your email address and select “Get Verification Code.” NOTE: You will use your email

address to log into your account in the future.

• The app will send an email with a verification code. Type the verification code in the app.

• Enter a password and select “Done”.

Adding the SECUR360 Device

• IMPORTANT: Before adding the device to the app, ensure your mobile device is connected to

the same wi-fi network that the device will be using.

• Allow the device 1 minute to fully boot-up. The LED indicator behind the lens on the motion

sensor will blink RED when complete.

• On your mobile device, open the SECUR360 app.

• Ensure the app is showing the Home screen. If not, press the Home icon at the bottom of the

screen.

• To add a device, press the “+” icon at the top of the screen or the “Add a Device” button.

• Ensure “Add Manually” is selected at the top of the screen.

• Select “HeathZenith” in the left-hand column and then select the correct device icon on the

right.

• Press “Confirm indicator slowly blinks” button.

• Ensure the correct network is selected and type the network password. Press “Confirm”. The LED

indicator will blink BLUE while connecting to the internet.

• Once the device is connected to the internet (LED is a steady BLUE), use the app to control your

new device.

210166-01

CONNECTING TO YOUR NEW SECUR360 DEVICE

Page is loading ...