2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Security Lighting
  6. Ratio Wall Mount

Security Lighting Ratio Wall Mount Installation guide

  • Hello! I've reviewed the installation instructions for the Hubbell Lighting RATIO ACCESSORY RA-WM-ACC wall mount. This document details the mounting steps, required materials, and specifications needed for proper installation. The mount is designed for use with RATIO AREA luminaires and requires caulking to achieve a water-tight seal. I'm ready to answer any questions you have about its installation process or features.
  • What type of luminaires is the RA-WM-ACC wall mount compatible with?
    What is the mast arm fitter secured with?
    What is required to seal the perimeter of the wall bracket?
Catalog Number: RARWBXX
Instruction Sheet:
93099925 Rev A
Shipping Package Contents:
Wall Adapter Adapter
Material:
Aluminum
Finish:
Powdercoat Paint
Weight:
1.4 lbs
RA-WM-ACC WALL MOUNT
RATIO ACCESSORY
Hubbell Lighting
701 Millennium Blvd.
Greenville, SC 29607
Technical Support: (864) 678-1000
Fax: (864) 898-1065
www.hubbell.com
Compatible with: RATIO AREA
RATIO AREA SMALL (SHOWN)
REQUIRES VERSION WITH MAF MOUNT OPTION
MAST ARM FITTER [MAF] WITH
4X 3/8-16 SET SCREWS
TIGHTEN TO 12 ft.-lbs. TORQUE
Mounting Notes:
Position the wall mount plate over the Junction Box onto
mounting surface in desired position and mark surface for (4)
mounting holes.
At marked positions, drill and install (4) 3/8-16 to 1/2-13 wall
anchors (not provided) that are appropriate for use with the
surface material.
Route the power leads from the fixture through the tenon of
the wall mount tenon and into the junction box. Make the
wiring connections.
Place the wall mount onto the mounting surface and align
with anchors. Using (4) fasteners, secure accessory to
mounting surface.
Use RTV Silicone to caulk around the perimeter of the wall
plate, creating a water-tight seal.
Mount fixture to the wall mount and tighten (4) 3/8-16 set
screws of mast arm fitter assuring fixture is level. Tighten
set screws to 12 ft.-lbs. torque.
1.
2.
3.
4.
5.
6.
NOT INCLUDED
4X HARDWARE SET
BOLTS, WASHERS,
WALL ANCHORS
WALL MOUNT ADAPTER
APPLY A BEAD OF SILICONE CAULK AROUND
THE PERIMETER OF WALL BRACKET FLANGE
TO SEAL THE INSTALLATION.
/