Hubbell Wiring Device-Kellems PD2044 Installation guide

  • I have reviewed the installation instructions for the 3 AMP Power Supply Cord. This document provides crucial information on proper installation, safety precautions, and testing procedures. I'm here to assist with any questions you may have about the device or the instructions provided.
  • What should I do before connecting the power?
    What should I do if I see any damage to the connector or cable?
    How tight should the coupling nut be for fixed installations?
    Can this device be connected under load?
PD2044(Page 1) 2/05
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
185 Plains Road
Milford, CT 06460-8897
(203) 882-4800
®
GENERAL INFORMATION
1. NOTICE: For installation by a qualified electrician in accordance with national and local electrical codes and the following instructions.
2. CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing. Never wire energized components.
3. NOT FOR INTERRUPTING CURRENT. DO NOT CONNECT OR DISCONNECT UNDER LOAD.
4. CAUTION: To ensure seal of enclosure to Type ratings, tighten coupling nut firmly against mating connector. This connector
is rated Enclosure Types 4, 4X, 12, 13 when fully connected to a mating LinkosityTM connector or receptacle having an
equivalent Enclosure Type rating.
5. Check that the devices’ Enclosure Type Rating and electrical ratings are suitable for the application.
INSTALLATION & USE
1. Do not connect to power before conducting the following electrical tests:
Test continuity of wiring to verify correct polarity and phasing.
Measure insulation resistance to be sure the system does not have any short circuits or unwanted grounds.
2. CAUTION: If any parts of the connector or cable appear to be missing, broken or show signs of damage: DISCONTINUE USE
IMMEDIATELY! Replace damaged component. Failure to could cause serious injury or equipment damage.
3. Coupling nuts to be hand-tight.
4. For fixed installations coupling nut must be wrench tight - 1/4 turn beyond hand-tight.
INSTALLATION INSTRUCTIONS
LINKLINK
LINKLINK
LINKOSITYOSITY
OSITYOSITY
OSITYTMTM
TMTM
TM 3 3
3 3
3 AMP POAMP PO
AMP POAMP PO
AMP POWER SUPPLWER SUPPL
WER SUPPLWER SUPPL
WER SUPPLY CORDSY CORDS
Y CORDSY CORDS
Y CORDS
CONTACT LOCATIONS FOR LINKOSITYTM CONNECTORS
MALE FACE VIEW WIRING CODE FOR LINKOSITYTM CONNECTORS
FEMALE FACE VIEW
2P 3P 4P 5P 2P 3P 4P 5P
Linkosity TM is a trademark of Lockheed Martin.
2P 3P 4P 2P 3P 4P
1/1