Talaris NMD50 Setup

Hello! I've analyzed the document regarding the NMD50 Proper Cassette Setup. It seems to cover important aspects such as cassette lock verification, bill length rail adjustments, proper loading procedure, and cassette memory clearing. I'm ready to answer any questions you might have about these processes.
How to remove the cassette from the bill dispenser?

What is the required height of the cassette?

What are the correct positions for Bill length rails?

NMD50ProperCassetteSetup



1. RemoveCassettefromtheBillDispenser

a. UsetheUnLockbuttonontheDiagnosticsscreen

2. VerifytheCassetteLockinnotbroken

3. OpenCassette

4. Removeallbills

5. VerifyCassetteheightisat9(Bothsides)



6. VerifyBilllengthrailsareatH(left)andI(right)



Grasp Guide

and move

toward front of

cassette while

lifting up

Indicator Tab

H for Left side

I for Right Side

Cassette Latch

Cassette Lock

Indicator Tab

Adjustment Screw



a. IfAdjustmentisnecessary

Guide can now be

adjusted from side

to side to achieve

specifications



7. VerifyPusherPlateisnotskewedbothdirections



8. Properlypreparebills



Flip through the stack of

Bills to check condition.

• Remove any bills that

are in poor condition

• Remove any double

folded bills from the

stack

Gap

GOOD

BAD

Skewed

9. ProperlyLoadbillsintheCassette



10. PullouttheWhitelockingTabsongreenpusherbar



11. Properlyclosethecassette

Close Cassette by

pressing down on the

green dot until the latch

release button is fully

engaged

Pull white tabs out

before closing

cassette.

White Tabs

Use only

notes in good

condition and

align them

evenly



12. Re‐insertthecassetteintotheBillDispenser

13. Clearthememoryofthecassette

a. UsetheClearMemorybuttonontheDiagnosticsscreen



Talaris NMD50 Setup

Other documents