2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Hobart
  7. HL1400N Hose Bracket Kit

Hobart HL1400N Hose Bracket Kit User manual

  • Hello! I've reviewed the instructions for the HOBART HL1400N Hose bracket kit. This document covers installation, uninstallation, operation, and cleaning procedures for the hose bracket. It details the compatibility with Baxter and Domix hose hooks and describes how the bracket mounts to the wire cage. I am ready to assist with any questions you might have about this product and its usage.
  • What hose hooks are compatible with the hose bracket?
    How do I install the hose bracket?
    How do I uninstall the hose bracket?
    How often should I clean the hose bracket?
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937-332-3000
WWW.HOBARTCORP.COM
FORM 0F-048158 (MAY 2021) PRINTED IN U.S.A.
HOSE BRACKET
HOSE HOOK
WIRE CAGE
HL1400N HOSE BRACKET KIT
HOSBRKT-HL140N, PART #00-938891
INSTRUCTIONS
Disconnect electrical power supply and follow lockout/tagout procedures.
The hose bracket is only for use with standard Baxter and Domix water
meter hose hooks.
Component Reference
Fig. 1
Install
1. Select one of the five mounting positions shown for the hose bracket (Fig. 2).
Fig. 2
2. Lower the two bracket mounting hooks between the first and second horizontal wires
from the top of the wire cage (Fig. 3).
Fig. 3
MOUNTING
HOOK
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937-332-3000
WWW.HOBARTCORP.COM
FORM 0F-048158 (MAY 2021) PRINTED IN U.S.A.
3. Slide the hose bracket tab (Fig. 4) under the fourth horizontal wire as shown. The hose
bracket is now installed.
Fig. 4
4. Install the hose hook through both eyelets in the hose bracket (Fig. 5).
Fig. 5
Uninstall
1. The hose hook and hose bracket can be uninstalled by reversing the install procedure
above.
Operation
1. Make sure a bowl is properly installed and in the fully raised (mix) position. Refer to the
mixer instruction manual as needed.
2. Make sure the wire cage is in the closed, front-center position. Refer to the mixer
instruction manual as needed.
3. Install the hose bracket and hose hook by following the install section instructions.
4. Follow the water meter instructions to dispense a desired amount of water into the bowl.
5. Install/uninstall the hose hook and hose bracket as needed for regular mixer operation.
Cleaning
Clean the hose bracket daily.
1. Uninstall the hose bracket by following the instructions above.
2. Thoroughly wash the hose bracket with hot water and a mild soap solution, rinse with
either a mild soda or vinegar solution and thoroughly rinse with clear water.
EYELETS
TAB
/