2. Home
  3. Home security & automation
  4. Security device components
  5. Naval Electronics AB
  6. PR-20BE

Naval Electronics AB PR-20BE Installation guide

  • I have reviewed the provided Installation Instructions for Naval Electronics, Inc. Active Antenna Power Supplies PR-12, PR-12BE and PR-20BE. This document details how to install and configure the power supplies, which accept either 110 or 220VAC and 12 or 24VDC inputs, and includes component layout diagrams. I'm ready to answer your questions about these devices.
  • What AC voltages can the power supply accept?
    What DC voltages can the power supply accept?
    How is the strapping changed for different AC voltages?
Naval Electronics, Inc. 7028 West Waters Ave Suite 393, Tampa, Florida USA 33634
Phone (813) 885-6091, Fax (813) 885-3601, E-mail [email protected]
Installation Instructions
PR-12, PR-12BE and PR-20BE Active Antenna Power Supplies
All power supplies are strapped for either 110 or 220 VAC at the factory.
The strapping can be changed by a qualified technician in the field, as shown on the
diagram at the bottom of this page.
The AC input block accepts either 110 or 220VAC (depending on strapping).
Pin 1 AC Hot (connect one AC lead here)
Pin 2: Not used.
Pin 3: Neutral AC (connect other AC lead here).
Pin 4: Ground or Cable Shield
The DC input block accepts either 12 VDC or 24 VDC.
Pin 1: +12VDC
Pin 2: +24VDC
Pin 3 Negative
Naval Electronics, Inc. 7028 West Waters Ave Suite 393, Tampa, Florida USA 33634
Phone (813) 885-6091, Fax (813) 885-3601, E-mail [email protected]
PR-12BE Component Layout Diagram
PR-20BE Component Layout Diagram
Blue Transformer
Red LED
Over Current
Indicator
Green LED
Power Indicator
Antenna
Output1
Output2
Note: to config 220v or 110v
1. 220V Plug jumper only No.1
2. 110V: Plug jumper both No.2 and No.3
Short2&3 Short 1&3
PR-20BE
Naval Electronics, Inc 7028 W Waters AVE, #393, Tampa, FL 33634
Phone :+ 1-813-885-6091, email : [email protected]
DC Fuse 150MA
1
Jumper For 220V
For 110V
2
3
Jumper
Short 2&4
AC Fuse 150MA
Power
24V12V GND
AC N/C AC GND
Signal
Attenuator
Red LED
Over Current
Indicator
Green LED
Power Indicator
Antenna
Output1
Output2
PR-12BE
110v
220v
Jumper
AC Fuse
150MA
Signal
Attenuator
24V
12V
GND
AC
N/C
AC
GND
DC Fuse 150MA
Naval Electronics, Inc 7028 W Waters AVE, #393, Tampa, FL 33634
Phone :+ 1-813-885-6091, email : sales@naval.com
Transformer
/