TM
1
9109-A2-GK40-00
November 1996
9109 E&M Analog Voice APM and
9109 FXS Analog Voice APM Errata
Document Number 9109-A2-GK40-00
November 1996
This document contains information not included in the user documentation.
Keep this document with your T1 access unit’s documentation.
Change to the Cable Installation
Replace the procedure in the
Connecting to Analog Voice Equipment
section of
the following documents:
9109 E&M Analog Voice Application Module (APM) Installation Instructions
(Document No. 9109-A2-GN11-00)
9109 FXS Analog Voice Application Module (APM) Installation Instructions
(Document No. 9109-A2-GN12-00)
Turn this page over for the procedure.
2
9109-A2-GK40-00
November 1996
" Procedure
1. Remove the bottom Jack-screw from the I/O card, below the 50-position
interface.
2. Align the anchor mount provided with the screw hole, reinsert the
Jack-screw, and tighten it securely.
3. Feed the cable tie provided through the anchor mount, about 2/3 of the way.
4. Plug in the 50-pin end of the cable, and secure the connector by screwing
the top cable screw into the top Jack-screw.
5. Wrap the long end of the cable tie around the cable, and feed it through the
other end of the cable tie, tightening the cable to the anchor mount, then
clipping the excess.
6. Connect the other end of the cable to the M66 block.
496-1518
1
Anchor
Mount
Jack-Screw
50-Pin
Connector
496-15151
M66 Block
496-15171
M66 Block
Voice APM's
P1
P2
P3
P4
496-15172
M66 Blocks
Voice APMs
TX
RX E&M
Signal Ground
and Battery
P1
P2
P3
P4 P5 P6 P7
3
9109-A2-GK40-00
November 1996
The following illustrations show fully connected voice ports.
/
