Serial Number

Decal

Model No. PFTL14011.1

Serial No.

Write the serial number in the space

above for reference.

CAUTION

Read all precautions and instruc-

CONTACT THE STORE; please

contact Customer Care.

IMPORTANT: Please register this

product (see the limited warranty

on the back cover of this manual)

before contacting Customer Care.

CALL TOLL-FREE:

1-888-533-1333

Mon.–Fri. 6 a.m.–6 p.m. MT

Sat. 8 a.m.–4 p.m. MT

warning decals. If a decal is missing or

illegible, call the telephone number on the

front cover of this manual and request a

free replacement decal. Apply the decal in

the location shown. Note: The decals may

not be shown at actual size.

WARNING DECAL PLACEMENT

OPERATION AND ADJUSTMENT .............................................................16

HOW TO FOLD AND MOVE THE TREADMILL ...................................................29

TROUBLESHOOTING ......................................................................30

EXERCISE GUIDELINES ....................................................................33

PART LIST. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .34

EXPLODED DRAWING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .36

ORDERING REPLACEMENT PARTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Cover

LIMITED WARRANTY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Cover

TABLE OF CONTENTS

IMPORTANT PRECAUTIONS

treadmill offers an impressive selection of features

designed to make your workouts at home more enjoy-

able and effective. And when you’re not exercising, the

unique treadmill can be folded up, requiring less than

half the oor space of other treadmills.

For your benet, read this manual carefully before

using the treadmill. If you have questions after

model number and serial number before contacting us.

The model number and the location of the serial num-

ber decal are shown on the front cover of this manual.

Before reading further, please review the drawing

below and familiarize yourself with the labeled parts.

BEFORE YOU BEGIN

Handrail

PART IDENTIFICATION CHART

number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see if it is preat-

tached. Extra parts may be included.

ASSEMBLY

the Base (105).

97

5

Partially tighten the 3/8" x 2 3/4" Screws (8) and

the 3/8" x 1 1/4" Screws (9) until the heads of the

Screws touch the Left Upright (90); do not fully

tighten the Screws yet. Note: It may be help-

ful to use the Short Hex Key (43) on the Screw

shown.

Attach the Right Upright (not shown) in the

same way. Note: There are no wires on the right

side.

90

105

4

9

8

14

OPERATION AND ADJUSTMENT

Use a Surge Suppressor

Your treadmill, like other electronic equipment, can be

damaged by sudden voltage changes in your home’s

power. Voltage surges, spikes, and noise interfer-

ence can result from weather conditions or from other

appliances being turned on or off. To decrease the

risk of damaging the treadmill, always use a surge

Use only a surge suppressor that is UL 1449 listed as a

properly installed and grounded in accordance with all

local codes and ordinances. The outlet must be on a

not plug other electrical devices, except for low-

power devices such as cell phone chargers, into

the surge suppressor or into an outlet on the same

circuit. IMPORTANT: The treadmill is not compat-

ible with GFCI-equipped outlets and may not be

compatible with AFCI-equipped outlets.

A temporary

adapter may

be used to

connect the

surge sup-

pressor to

a 2-pole

receptacle

be connected with a metal screw to a permanent

ground such as a properly grounded outlet box cover.

Some 2-pole receptacle outlet box covers are not

grounded. Before using an adapter, contact a quali-

fied electrician to determine whether the outlet box

cover is grounded. The temporary adapter should

be used only until a properly grounded outlet can

be installed by a qualified electrician.

Surge

Grounded Outlet

2

2-pole Receptacle

Lug

The treadmill console offers an impressive array of

features designed to make your workouts more effec-

tive and enjoyable. The console features revolutionary

iFit technology that enables the treadmill to communi-

cate with your wireless network. With iFit technology,

you can download personalized workouts, create your

own workouts, track your workout results, and access

many other features. See www.iFit.com for complete

information.

In addition, the console features a selection of onboard

distance, or pace goal.

When you use the manual mode, you can change the

speed and incline of the treadmill with the touch of a

button.

cise feedback. You can also measure your heart rate

using the handgrip heart rate monitor or the chest heart

rate monitor.

You can even browse the Internet or listen to your

favorite workout music or audio books with the con-

sole’s stereo sound system while you exercise.

To turn on the power, see page 18. To learn how to

use the touch screen, see page 18. To set up the

console, see page 19.

Plug in the power cord (see

page 16). Next, locate the

power switch on the treadmill

frame near the power cord.

Make sure that the switch is

in the reset position.

IMPORTANT: The console features a display demo

mode, designed to be used if the treadmill is dis-

played in a store. If the demo mode is turned on,

the displays will show a preset presentation after

you plug in the power cord and press the power

key. To turn off the demo mode, see step 7 on page

Next, stand on the foot

rails of the treadmill.

After several seconds,

the displays will light. IMPORTANT: In an emergency,

the key can be pulled from the console, causing

the walking belt to slow to a stop. Test the clip by

carefully taking a few steps backward; if the key is

not pulled from the console, adjust the position of

the clip.

Note: It may take a minute for the console to be

ready for use.

to move certain images on the screen, such as

the displays in a workout (see step 5 on page 20).

However, you cannot zoom in and out by sliding your

ngers on the screen.

• The screen is not pressure sensitive. You do not

need to press hard on the screen.

• To type information into a text box, touch the text

box to view the keyboard. To use numbers or other

characters on the keyboard, touch the ?123 but-

ton. To view more characters, touch the Alt button.

keyboard. To return to the letter keyboard, touch the

capital characters, touch the arrow button again. To

return to the lowercase keyboard, touch the arrow

Back button to return

to the previous screen.

Press the Home button to

return to the main menu.

workouts, and use other features of the console,

you must be connected to a wireless network.

See HOW TO USE THE WIRELESS NETWORK

MODE on page 27 to connect the console to your

wireless network.

2. Check for rmware updates.

First, see step 1 on page 25 and step 2 on page 26

and select the maintenance mode. Then, see step

3 on page 26 and check for rmware updates.

during assembly).

browser, see page 28. The browser will open to the

iFit.com home page. Touch the Register button in

the upper-right corner of the screen.

other features that the console offers.

To use the manual mode, see page 20. To use an

onboard workout, see page 22. To use a set-a-goal

workout, see page 23. To use an iFit workout, see

page 24.

To use the equipment settings mode, see page 25.

To use the maintenance mode, see page 26. To use

the wireless network mode, see page 27. To use

the stereo sound system, see page 28. To use the

Internet browser, see page 28.

IMPORTANT: If there are sheets of plastic on the

the treadmill, observe the alignment of the walking

2. Select the main menu.

When you turn

on the power,

the main menu

should appear

after the

console boots

up. Touch the

home button in

the lower-left

corner of the screen (not shown here) to return to

Touch the Start button on the screen or press the

Start button on the console to start the walking

belt as desired by pressing the Speed increase and

decrease buttons. Each time you press one of the

buttons, the speed setting will change by 0.1 mph;

if you hold down the button, the speed setting will

change in increments of 0.5 mph.

If you press one of the numbered Quick Speed

buttons, the walking belt will gradually change

speed until it reaches the selected speed setting.

To select a speed setting that includes a decimal—

such as 3.5 mph—press two numbered buttons in

succession. For example, to select a speed setting

of 3.5 mph, press the 3 button and then immedi-

ately press the 5 button.

To stop the walking belt, press the Stop button. To

restart the walking belt, press the Start button.

4. Change the incline of the treadmill as desired.

5. Monitor your progress.

The console

offers sev-

eral display

modes. The

display mode

that you select

will determine

which workout

information is

shown. To select the desired display mode, simply

tional information by touching the red boxes on the

As you walk or run on the treadmill, the screen can

show the following workout information:

have a time left countdown.)

• The approximate number of calories you have

burned

• The approximate number of calories you are

burning per hour

• The distance that you have walked or run

• The number of vertical feet you have climbed

• The speed of the walking belt

• Your pace in minutes per mile

• Your current lap number