MANUALLY (RE-)REGINSTER THE REMOTE SENSOR
If the battery is low and needs to be replaced or the communication between the main
unitandremotesensorisinterruptedfor35minutes,theoutdoorreadingdisplays‘--,-’.
It is also possible that your weather station is receiving information from your neigh-
bour which might be using the same frequency and channel.
You can re-register your outdoor sensor manually.
• Removethebatteriesfromtheremotesensorforafewseconds.
• Re-installthebatteriesinthecorrectpolarity.ThetransmissionLED
willash
every2seconds.
• Presstheoutdoorsensorchannelselectbutton
to chose the desired channel
(1,2or3).ThetransmissionLEDwillashevery2secondsasmanytimesasthe
selected channel.
• Pressandholdthe[CH]buttononthemainunitfor2secondstoactivatethe
search mode. A brief beep is audible and a remote sensor channel number (1-3)
startstoash.
• Makesurethattheremotesensorisinstalledwithinrange(maximum50minan
open area).
• Theweatherstationwilldetecttheremotesensorandtheremotesensortempera-
ture will be displayed.
• Pressandholdthe[CH]buttononthemainunitfor2secondstoexitsearchmode.
• Ifnobuttonispressed,searchmodewillautomaticallystopafter2minutes.
DCF77 RADIO CONTROLLED CLOCK (RCC)
TheremotesensorreceivesthetimesignaltransmittedbyPhysikalisch-Technische
Bundesanstalt(PTB)ofGermany.Inaveragethistimedeviateslessthan1second
in2millionyears.PTBtransmitsthetimesignal(DCF77,77.5kHz)continuouslyfrom
MainingennearFrankfurtamMain.Itisexpectedthatthesignalcancoveradistance
of more than 1,000 km from the transmitter. Then the remote sensor transmits the time
signal to the weather station to display the accurate time. However, there are many
environmentfactorsthatmayaffecttheRCCreception(nearbycomputermonitorsor
otherelectronicdeviceslikeTV,metalsurfacesetc.).Pleaseplacetheremotesensor
away from metallic structures and face the transmitter in the direction of Frankfurt a.M.
SET THE CLOCK
IfDCFreceptionfails,oryouwanttosetyourdesiredtime,pleasefollowthesteps
below:
1. Pressandhold[MENU/SETUP]buttonfor2secondstoenterclocksettingmode,
thehourvaluebeginsashingatthefrequencyof1Hz.
2. Press[▲]or[▼]buttononcetoincreaseordecreasethehourvaluebyonehour.
3. Press[MENU/SETUP]buttontoconrmthehourvalue.
4. Theminutessettingmodebeginsashing.
5. Press[▲]or[▼]buttontosetyourdesiredminutevalue.Holdingdowneitherbut-
tonwillincreaseordecreasetheminutesrapidly.Press[MENU/SETUP]buttonto
conrmtheminutevalue.
(ENG)
~26~