INTRODUCTION
The SHOP FOX
®
Model D3236 Large 2 Shelf
Cart is perfect for moving bulky items around
your shop.
Check the inventory list below
Figure 1 to
ensure all the parts are present.
To assemble the Model D3236, do these steps:
1.
Install the 2 swivel casters on the handle
side of the bottom shelf using hardware
bag 1. Install the fixed casters on the
opposite end of the cart. The bottom shelf
has predrilled holes in each corner.
2. Attach the 4 side braces to the outside of
the bottom cart shelf with the hardware
from bag 2. The rest of the cart will be
assembled using the remaining hardware
from bag 2.
3. Install the top shelf (with the SHOP FOX
®
logo).
4. Install the cart handle brackets to the end
of the top shelf attachment point, using
the same hardware that secures it to the
side braces.
5. Tighten down all the hardware to complete
the cart assembly.
Instruction Sheet
Model D3236
Large 2 Shelf Cart
Figure 1. Cart fully assembled.
COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
NOVEMBER 2003, PRINTED IN CHINA.
INVENTORY LIST
• (2) Swivel Casters
• (2) Fixed Casters
• (2) Handle Brackets
• (1) Handle
• (4) Side Braces
• (2) Shelves
• Hardware Bag 1
(16) Hex Bolts M8-1.25 x 14
(16) Hex Nuts M8-1.25
(16) Flat Washers 8mm
• Hardware Bag 2
(48) Hex Bolt M6-1 x 13
(48) Hex Nuts M6-1
(48) Flat Washers 6mm
CAUTION—THIS CART IS NOT INTENDED TO BE
USED BY CHILDREN!
D3236 Parts Diagram
1 XD3236001 HANDLE
2 XD3236002 HANDLE BRACKET
3 XD3236003 SIDE BRACE
4 XD3236004 TOP SHELF
5 XD3236005 BOTTOM SHELF
6 XD3236006 CASTER
7 XPN01M HEX NUT M6-1
8 XPW03M FLAT WASHER 6MM
9 XPB02M HEX BOLT M6-1 X 12
10 XPB84M HEX BOLT M8-1.25 X 14
11 XPW01M FLAT WASHER 8MM
12 XPN03M HEX NUT M8-1.25
13 XD3236013 SHOP FOX LOGO STICKER
1
2
3
4
5
6
7
8
9
10
11
12
13
REF PART # DESCRIPTION
If you have questions please contact Woodstock
International at 1-360-734-3482 or send e-mail
.
/