Geek Chef GWS-A30A User guide

Type
User guide
1
MAINTENANCE
Proper maintenance of the Range Hood will
assure proper performance of the unit.
F
ilters
The filters must be cleaned approximately once
every 30 hours of operation.
Grease filters are dishwasher safe.
Remove filter by pushing filter towards the back
of hood and rotating filter downward.
D
uct free (Carbon) Filters-buy separately
The duct free filters should be changed every 6
months. Rotate the filters to remove and replace.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its
fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water
marks.
For discolorations or deposits that persist, use a non-scratching household cleanser or stainle
ss
st
eel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with cleanser an
d
w
ater. Rub lightly in direction of polishing lines or "grain" of the stainless finish. Avoid using to
o
much pressure which may mar the surface.
Don’t allow deposits to remain for long time.
Don’t use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface
causing rust.
Don’t allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact
with stainless steel for extended periods. Many of these compounds contain chemicals which
may be harmful. Rinse with water after exposure and wipe dry with a clean cloth
.
P
ainted surfaces should be cleaned with warm water and mild detergent only.
Filter
2
After you have connected the appliance to the mains supply the backlight will turn on. It will turn
of
f after 5s without any operation and the hood will enter stand-by mode.
TOUCH CONTROLS
P
ress one of the speed butt
ons
to turn the appliance on.
P
ress the button
for low speed. Push the button again and the motor will stop.
P
ress the butt
on
for medium speed. Push the button again and the motor will stop.
P
ress the butt
on
for high speed. Push the button again and the motor will stop.
P
ress the butt
on
and the lights will come on. Push the button again and lights will turn
off.
W
hile the range hood is in use, if you press the timer butt
on
once, the range hood will run
for 5 minutes and then enter stand-by mode.
LED LIGHTS
A
lways switch off the electricity supply before carrying out any operations on the appliance.
To change the light:
Open the filter and find the spring of the light, push the spring and the light will be slip out. Change
the light as with same kind of 4Volt, 2.5 Watt LED light.
Caution:
Light may be hot, please rotate when the light is cool.
  • Page 1 1
  • Page 2 2

Geek Chef GWS-A30A User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI