WC-1414-48
Installation Guide
Prior to installation please check received
Please report any missing items to your
Protect all surfaces from sharp objects,
high heat sources, direct prolonged
sunlight and chemical hazards.
Professionalinstallationrecommended.
items against the "Packing List".
retailer immediately .
0
1
2
3
4
1
2
3
0
0
m
m
"
-
C
H
N
REQUIRED TOOLS NOT IN BOX
Tape measure
Pencil
Electric Drill
Phillips Screwdriver
Adjustable Wrench
Spirit Level
Silicone sealant
adjust laterally
adjust depth
adjust height
Counter & sink / 1
PACKING LIST
Main cabinet / 1
Screws for mirror 2/
Mirror / 1 (may not be
included)
(Not all components may be included,depending upon your purchase)
HOW TO ADJUST HINGES (if required)
WC-1414-48
Installation Guide
6-8mm
4
5
INSTALLATION INSTRUCTIONS
Installer must cut appropriately sized hole
in back of cabinet to accommodate existing
placement of hot & cold wall valves and drains.
1
2
Install the counter. Seal around
the top of the cabinet with clear silicone
sealant.
3
(1)
(2)
(3)
6
Install the mirror: use a pencil to mark the
placement of the screw holes on the wall
,drill
the holes and insert the plastic wall anchors.
Install the screws into the wall anchors,
leaving enough of the screw exposed to hang
the mirror - approx 1/4" - 1/2".
Remove the handles from
inside the cabinet doors and drawers and
reinstall on the outside.Do not over-tighten
when reattaching.
Cut hole in back
of cabinet
Adjust the feet if needed.
Prior to installation please check received
Please report any missing items to your
Protect all surfaces from sharp objects,
high heat sources, direct prolonged
sunlight and chemical hazards.
Professionalinstallationrecommended.
items against the "Packing List".
retailer immediately .
Mirror cabinet / 1
PACKING LIST
adjust laterally
adjust depth
0
1
2
3
4
1
2
3
0
0
m
m
"
-
C
H
N
REQUIRED TOOLS NOT IN BOX
Cover / 4
adjust height
Tape measure
Pencil
Electric Drill
Phillips Screwdriver
Adjustable Wrench
Spirit Level
Silicone sealant
ADJUSTMENT OF HINGES (if required)
Screw / 2
INSTALLATION INSTRUCTIONS
1
2
3
(Components may be different depending on your order)
Insert the plastic wall anchors into holes.
Drill the screws into the plastic wall
anchors. Put covers onto screws.
Drill holes in the wall that line up
with the holes in the mirror cabinet.
Remove door by unscrewing hinges. Insert shelves. Hand-tighten screws on bracket.
Re-attach door.
4 5 6
WC-1414-MC24
Installation Guide
  • Page 1 1
  • Page 2 2
  • Page 3 3

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI