G07001 INSTALLATION INSTRUCTION
(A1)
10"~26"
Max:100x100mm/4x4"
Min:75x75mm/3x3"
TV
1 2
x3
x1
If you have any questions, please feel free to contact us:
USA E-mail: [email protected]
Before getting started, let’s make sure this mount is perfect for you!
1
Is your TV VESA
equal to/greater than
75x75mm/3x3" and
equal to/less than
100x100mm/4x4"?
2
Does your TV
(including accessories)
weigh less than
22 LBS (10 kg)?
4
Installation Tools
(Not Included)
Yes --- Perfect!
No --- This mount is NOT compatible.
MAX:100mm/4"
MAX:
100mm/4"
Yes --- Perfect!
No --- This mount is NOT compatible.
Band Tape
2m
2M2M
5
Safety Caution
Please read this instruction carefully before installation.
If you do not understand these instructions or have doubts about the safety of the
installation, assembly or use of this product, please feel free to contact Customer Service:
USA E-mail: gfw-cs@ohopeglobal.com
● The hardware provided in the package can only use in 0.5" thick or above wooden
board installation on RV.
● The wall must be capable of supporting five times the weight of the TV and mount
combined. According to the wall you're going to install, the structure of your RV may
require additional reinforcement.
● Incorrect installation may result in product damage or body injury. GOFORWILD shall
bear no responsibility for any damage or injury resulted from incorrect installation,
incorrect assembly or misuse.
● Do not apply this product to any purpose not indicated by GOFORWILD.
● Make sure to stow the TV and fully lock the mount in place before your RV is moving.
Pencil Screwdriver Electrodrill
Socket Wrench
1/2"(13mm)
3
Where can you
install this mount?
0.5"(12.7mm) thick or above wooden board
Min. 0.5"(12.7mm)
1/8"(3mm)
Wood Drill Bit
1
Parts and Hardware
WARNING:
This product contains small items that could be a choking hazard if
swallowed. Before starting assembly, verify all parts are included and undamaged. For parts
shortage or damage, please contact us via gfw-cs@ohopeglobal.com.
NOTE: Not all hardware included will be used.
M4x12mm
M6x12mm
M4 M6
WashersTV Screws
x4 x4
x4 x4
1-1 Disassemble Wall Plate Unit into Two Pieces
Wall Plate Unit
x1
Allen Key
x1
2
Wall Plate
TV Plate
M6
M4
1-2 Select TV Screws
1-3 Attach TV Plate to TV Back
Screw and Washer Combination Options
No!
100mm
75mm
75mm
100mm
3
Parts and Hardware
Min. 0.5"(12.7mm)
1/8"
(3mm)
Wall Plate
x4
CAUTION:
To avoid potential personal injury or property damage:
All 4 lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate
assembly. Ensure the wall plate assembly is securely fastened to the wall before continuing on to
the next step.
To prevent the TV falling down, the Bolt Head Must Keep UP at this step!!
The TV plate is off center about 0.63"/16mm to
the wall plate. Please consider this point, when
positioning your TV on the wall.
Wooden Board
Lag Bolt M6x25mm
4
0.63"(16mm)
TV plate center Wall plate center
Wall Plate
Bolt Head UP!
Level
Wall Plate
No!
22 LBS (10 kg)
Before hanging TV, please conduct "wall plate installation integrity test" first.
TV
1 2
5
Tilting bolts
4-1 Tilting angle adjustment (+5°/-15°)
：
Pull TV to your desired angle then fasten 2 tilting bolts with
Allen key .
4-2 TV leveling adjustment (±3°):
Loosen 2 leveling bolts on the rear of TV plate by maximum 2
turns, adjust to level, and retighten to secure.
Loosen
Tighten
Tilting bolts
6
-15°
+5°
Important ! Make sure to stow the TV and fully lock the mount in place
before your RV moves.
Push your TV to the wall. Pull down the strap and lock the TV plate to
the wall plate.
7
Pull down
the straps
Stow
Pull and hold the strap
Pull out
8
75mm
100mm
120mm
229mm
173mm
75mm
100mm
98mm346mm
130mm
+90°/-90°
68mm
+5°
-15°
Allen key storage: For easy adjustment, you might put the Allen key on
the wall plate as illustration.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
HERMA Panel IT User manual
-
Comrac COMLA95-1 Datasheet
-
Clinton Electronics CE-LA19 User guide
-
Mounting Dream MD2209 User manual
-
-
-
MOUNTPRO Dual Monitor Stand Mount, Height Adjustable LCD Monitor Desk Mount, Articulating Full Motion Tilt Swivel Monitor Arm - Fits 13" to 27" Computer Screens, Each Arm Holds up to 19.8lbs., VESA 75 100 User manual
-
gefran GFW 400-600A Installation guide
-
-
Vogel's 73201499 Datasheet
