How to Use and Read Kutir Tape Measure
There is much more a tape measure can do beyond measuring basic inches and fractions. With
many built-in features a tape measure can simplify common framing measurements and aid in
more complicated measuring and scribing projects. Kutir Tape measure made it one step easier
by adding a Magnetic Hook.
Kutir Tape Measure Features
Measurements
• 12″ (ft) increments highlight
• 16″ increments highlight – Common “on-center” measurement for many wall, floor, and roof
framing.
• 10 CM increments mark – Optional on-center floor tiles/framing to accommodate a standard
4×4, 4×8 sheet or any other measurements.
• Metric Scale – Metric scales can make math easier to work with compared to fractions.
• Bold Type – Our marks are bolder type if eyesight is an issue.
Blade Hook
• Magnetic Hook – Many tape measure hooks are traditional. Which is fine to attach with
something. But if you can’t attach with something like refrigerator, any steel beams, nail which
is nailed fully etc then you mostly need someone else help. Here we had solved this issue by
attaching magnetic hook. You can attach it with steel beams drop ceiling channels, and hvac
ductwork. Also you can use as a magnetic pick-up tool for anything that may fall out of reach.
It is a great help also long measurement.
Magnetic Hook in Use
• True Zero – Many tape measure hooks will move back and forth along the securing rivets to
account for the hook design thickness and provide an accurate measurement. If you count
the marks on the first 1″, you will notice a shortage of 1/16″ – 1/8″. (i) Push the hook all the
way in for an inside measurement; e.g. interior of a cabinet. (ii) Pull the hook all the way out
for an outside measurement.
Tape Measure True Zero Tip
Blade
• Matte Blade – Helpful while working outdoors or under any light source. Normally glossy
blades reflects lights and it’s annoying to read the measurement. We made it matte non
glossy to make your measuring experience better.
Matte Blade outdoor work without any problem
• Sturdy Blade – Our blade is sturdy 0.15mm thick which is enough to extend till 8 Feet without
attaching hook, With attaching it will go till 25 Feet without problem.
Scribing
• Scribe Mark – Helpful in locating where you want to screw, nail, drill, or cut if a pencil is not
available or easily available. Place the tape measure at the edge of the material, at the
measurement wanted, let’s say 10″, then place the blade tip and mark the material where it
needs to be cut.
Tape Measure Scribing Ability
• Pencil Scribe Placement – (i) Hook onto an edge of material and lock your tape measure to
a specific measurement. (ii) Hold a pencil or other marking tool tight against the body and
tape edge. (iii) Pull both the tip and body along the material to create a marking
line. (iv) Always drag a scribing pencil for a smooth operation. Pushing can lead to a
restrictive motion. Note: This procedure may take some practice on scrap material to hone
your technique, pencil angle, pencil design, etc.
Tape Measure Quick Pencil Scribing
Thank you for putting your trust on us and let me know if you face any problem or need any tips.
Regards,
Ekram
Founder, Kutir
Below are some of our good quality products. Have a look if you are in need of any of those.
Magnetic Calendar Utility Knife
Amazon Link: https://goo.gl/7eecB6 Amazon Link: https://goo.gl/7KRCNS
/
