IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTALLATION
GUIDE
TEMPERATURE SENSOR KIT
FOR USE WITH INTELLICENTER™, EASYTOUCH®,
INTELLITOUCH®, SUNTOUCH® AND COMPOOL®
TO EASYTOUCH UPGRADE CONTROL SYSTEMS
Temperature Sensor Installation Instructions Temperature Sensor Installation Instructions
2
Technical Support
(800) 831-7133
8.00 am to 8.00 pm ET
8.00 am to 5.00 pm PT
Kit contents
The following items are included in the water/air temperature sensor
replacement kit:
Temperature Sensor Assembly - P/N 520872
• Temperature Sensor, 10k Temperature Sensor - P/N 520326
• Temperature Sensor, 10k Ohms, 40 ft - P/N 521583
• Temperature Sensor, 10k Ohms, 20 ft - P/N 521584
• Hose Clamp (1-7/8” - 5” Clamp) - P/N 476168
• Installation Instructions (this manual)
Water/Air Temperature Sensor
The sensor can be used as a water or air sensor. The 10k Ohms Temperature
Sensor can be is used with IntelliCenter, IntelliTouch, EasyTouch, SunTouch and
Compool to EasyTouch Upgrade Control Systems.
Related manuals
IntelliCenter™ Control System User’s Guide (P/N 522990)
IntelliTouch® Control System User’s Guide (P/N 521075)
EasyTouch® Control System User’s Guide (P/N 521044)
SunTouch® Control System User’s Guide (P/N 520785)
P/N 520326 Rev.E 5/2019
Temperature Sensor Installation Instructions
3
Note: See page 4 and 5 for circuit board sensor connector locations.
1. The existing water sensor is located between the filter pump and the
filter. Remove the sensor.
2. Drill a 3/8th inch hole in the 3-in or 2-in pipe. Position the hose clamp
over the replacement sensor and gently tighten around pipe.
Caution: Do not overtighten clamp.
3. Route the cable up through the low voltage compartment of the Load
Center or Power Center to the Outdoor Control Panel circuit board.
4. Strip wires back 1/4 inch. Connect the sensor wires to WATER screw
terminals. See page 4 and 5 for screw terminal location.
Ambient Air Temperature (Freeze Protection)
Sensor Replacement
• Mount sensor in open air, in shaded area, away from air conditioners.
Route the cable up through the low voltage compartment of the Load
Center or Power Center to the Outdoor Control Panel circuit board. Use
cable ties to fasten sensor cable to pipes. Strip wires back 1/4 inch.
Connect the sensor wires to AIR screw terminals. See page 4 and 5 for
screw terminal location.
When replacing the existing water temperature sensor, be sure to
use drill a 3/8th inch hole into the 3-in or 2-in pipe for the new sensor.
Note: The existing water sensor hole is 5/16th inch, and will not fit the
new replacement sensor.
IMPORTANT NOTE: Replacing the existing Water Temperature Sensor.
3/8"
Drill
Pipe
Clamp
2-in or
3-in Pipe
Sensor Installation
Temperature Sensor Installation Instructions Temperature Sensor Installation Instructions
4
IntelliTouch® Control
System Circuit Board
EasyTouch® Control
System Circuit Board
IntelliCenter Control System Circuit Board
(Air, Water and Solar sensor location)
AIR
SOLAR
WATER
AIR
SOLAR
WATER
(J15)
IntelliCenter™ Control
System Circuit Board
Temperature Sensor Installation Instructions
5
SunTouch® Control
System Circuit Board
VALVE ACTUATORS
INTAKE
RETURN
SOLAR
AUX 3
PUMP
AUX 2
AUX 1
VLV A VLV B VLV C
ONLY
SOLAR
CLNR
GAS
HEATER
RESET
CR2032
+3V
J12
A
J9
10K OHM THERMISTOR SENSORS
(Red/Blk wires are interchangeable)
to EasyTouch Indoor Control Panel
or iS10 Spa-Side Remote (for CP3800 series)
to CONTROL PANEL
or iS10
COMPOOL® TO EASYTOUCH® WIRING DIAGRAM
SENSORS
AI RSOL AR
TRANSFORMER
CONNECTIONS
18VAC10VAC 24VAC
RED
BLU
RED/ WH
ORG
ORG/ WH
BLU/ WH
PCB Assy #521099
MODTELSPAEXT CTRL
2-SPDSOL AR EHTR AUX7 AUX6 AUX5 AUX4 AUX3 AUX2 AUX1 PUMPSPA VLV BVLV ARETURNINTAKE
COM PORT
BLK
GRN
YEL
RED
HEATER
RED
BLK
AIR SENSOR
WATER SENSOR
RED
BLK
RED
BLK
SOLAR SENSOR
J19
J24
J23
J2J3J4J5J7J8J9J10J11
J6
J25
[See Important Note]
J12J13J14J15J16J17J18
J21
J22
AUXILIARY RELAYS (1-7)
POOL HEATER
CONTROL
GAS VALVE
PRESSURE
THERMOSTAT
LIMIT
OFF
ON
WATER
IS4 REMOTE
3G4B ORGBLK2Y 1R
J20
TRANSFORMER
FACTORY WIRING
OUTPUT: 10
VAC
18
VAC
24
VAC
LOW VOLTAGE CIRCUIT BREAKERS
BLK
ORG
RED
YEL
GRN
BLU
COM PORT
RJ12 Adapter
EasyTouch
®
Indoor Control Panel
or iS10 for CP3800 series
RED
GRN
YEL
BLK
YEL
RED
GRN
BLK
10V 18V 24V
TO GAS HEATER TERMINALS FOR
REMOTE CONTROL OPERATION, OR
TO FIREMAN'S SWITCH CONNECTION.
CAUTION:
DO NOT BYPASS INTERNAL HEATER
THERMOSTAT, HIGH LIMIT SWITCH,
OR OTHER SAFETY DEVICES.
COM PORT: EasyTouch® Indoor Control Panel,
RF Transceiver, iS4, iS10 Spa side Remote,
IntelliFlo® VF IntelliFlo® VS, QuickTouch®
and CP/ET RJ12 Adapter for Indoor Control Panel.
IMPORTANT NOTE:
J25 Jumper is Factory
set on both pins.
For Single Body Systems,
the Jumper only needs to
be attached on 1 pin.
For Shared Equipment
Systems, the Jumper
needs to be attached
on both pins.
INTAKE
VALVE
ACTUATOR
RETURN
VALVE
ACTUATOR
AUX VALVE A
or SOLAR
ACTUATOR
AUX
VALVE B
ACTUATOR
and/or
BLU
BLU
Compool® EasyTouch®
Upgrade Control
System Circuit Board
Temperature Sensor Installation Instructions Temperature Sensor Installation Instructions
6 Notes
Temperature Sensor Installation Instructions
7
Notes
Temperature Sensor Installation Instructions Temperature Sensor Installation Instructions
8
2
2
1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000
10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000
WWW.PENTAIR.COM
All Pentair trademarks and logos are owned by Pentair. Intellicenter™, EasyTouch®, IntelliTouch®, SunTouch®,
Compool® are trademarks and/or registered trademarks of Pentair Water Pool and Spa, Inc. and/or its
aliated companies in the United States and/ or other countries. Because we are continuously improving
our products and services, Pentair reserves the right to change specications without prior notice. Pentair
is an equal opportunity employer.
© 2019 Pentair Water Pool and Spa, Inc.
This document is subject to change without notice.
P/N 520326 Rev.E 5/2019
*520326*
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Pentair Pool Temperature Sensor |IntelliCenter EasyTouch IntelliTouch SunTouch and Compool Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Pentair Pool Intellicenter Control System Installation guide
-
Pentair Pool EasyTouch Control System | 8 and 4 Pool and Spa Owner's manual
-
-
-
Other documents
-
Pentair INTELLICENTER Owner's manual
-
Pentair WWP-7696 Intellitouch Control System User manual
-
-
Pentair 521139 Installation guide
-
-
MICRO-AIR 347 EasyTouch RV User manual
-
-
-
Lifegard Aquatics 011018 Installation guide
-
