2. Lucky Dog
  3. CL 50597

Lucky Dog CL 50597, CL 51597 Operating instructions

  • Hello! I've reviewed the provided installation instructions for the Lucky Dog Weatherguard Kennel Cover. The document outlines a step-by-step process for assembling the cover's frame, including installing A-frame gable supports, two and three-way clamps, center ridge poles, and securing the cover with elastic tie downs. I'm ready to answer your questions about the installation process or the components involved.
  • What is the first step in the installation process?
    Where are the two-way end clamps installed?
    When are the three-way center clamps used?
    How is the kennel cover secured?
Fig.
3
Fig.
2
Fig.
1
S
TEP #1
Insert A-frame gable supports (Part L) into
center stands (Part G). Slide ends of tubing
down as far as possible.
S
TEP #2
Install the two-way end clamps (Part M) at
the center of each A-frame gable support
(Part L) that rests on corner stands
(Figure 1)
.
If installing on a 10' or 15' long kennel,
install
three-way center clamp (Part N) at the
center of
A-frame gable supports that rests
on center stands (Figure 2).
Center
ridge pole
(Part O) between A-frame gable supports and
tighten
(Figure 3).
S
TEP #3
Unfold kennel cover material and drape over
kennel cover frame. Secure with elastic tie
downs (Part P - not shown).
Hint!
Avoid over stretching the tie downs as
it could cause damage to grommets.
Parts
L-O
Hi-Rise 5'x5' 10'x5' 15'x5' 10'x10'
L
A-Frame Gable Supports 2 2 3 4 3
L A-Frame Gable Supports 2 2 3 4 3L
M
Two-Way End Clamps 2 2 2 2 2
N
Three-Way Center Clamps 0 0 1 2 1
O
Center Ridge Poles 1 1 2 3 2
P
Elastic Tie Downs (
not show
n)
8
8 12
14 14
OPTIONAL: WEATHERGUARD™ KENNEL COVER AND FRAME
INSTALLATION INSTRUCTIONS
To purchase a Weatherguard™ Kennel Cover for your Lucky Dog™ Kennel contact customer service at 1.800.955.2879
L
M
N
O
/