IMPORTANT: Ensure the cabinet is level, plumb and secured to the wall before installing
this product.
Important Notes:
Part letter identification is shown for service part purposes
Ensure packaging is disposed of in a safe
500 & 600 Bi Fold Unit
HD915090
Assembly
1
3
HKC0035/36
Using the template supplied spike
runner fixing positions.
Lift the support arm & press piston onto
the bracket pins.
2
environmentally friendly way
12mm
44mm
140mm
218mm
122mm
Screw x12
(14mm csk Euro screw)
Template x1
A
Piston x2
D
D
RH Support Arm x1
B
CLH Support Arm x1
Smove x2
4
Lay the doors face down and secure hinges.
Note: The joining hinge hole locations will
need to be drilled in the top door.
21.5mm
106mm
TOP DOOR
BOTTOM DOOR
35mm Bit
(12mm deep)
Screw x4
(4x16mm csk)
Hinge Arm x2
Joining
Hinge x2
5mm Bit
(12mm deep)
TOP
Screw x8
(4x16mm csk)
HD915090
Assembly
5
6 7
If using the lowest height shelf position,
this will need to be raised by 20mm.
Fit the door assembly to the unit
aligning the hinge and bracket arms
with plates. Clip into place.
Note: To remove the top hinge and support
arm from the plates, push the clip down
on the plate to release as shown.
96mm
(20mm above lowest shelf position)
TOP DOOR
BOTTOM DOOR
29.5mm
5mm Bit
(12mm deep)
224.5mm
Fit the door and cabinet plates.
Note: The plates are very
similar in design. Make sure
the correct plates are
used.
192.5mm
4.5mm Thick
89.5mm
19mm 51mm
FRONT EDGE
Door Plate x2
5.5mm Thick
Note: Clip to face towards
the bottom of the door
Cabinet Plate x2
Screw x4
(pre-fitted)
Screw x4
(pre-fitted)
Bracket cover x2
(LH & RH)
Adjustment
Left/Right
Up/Down Up/Down
/