Compact Washer
PRODUCT MODEL NUMBERS
W10778944A
03/2016
NTC3500F
WASHER DIMENSIONS
Installation spacing for recessed area or closet installation
All dimensions show recommended and minimum spacing allowed.
■ Additional spacing should be considered for ease of
installation and servicing.
■ Additional clearances might be required for wall, door, and oor moldings.
■ Additional spacing of 1" (2.5 cm) should be considered on all sides
of the washer to reduce noise transfer.
■ If a closet door is installed, the minimum air openings in the top and bottom of the door
are required. Louvered doors with aire openings in the top and bottom are acceptable.
■ Companion appliance spacing should also be considered.
37"
(940 mm)
23"
(584 mm)
21"
(533 mm)
3
/4"
(19 mm)*
*Minimum measurement with leveling feet installed.
IMPORTANT: Do not install or store the washer where it will
be exposed to the weather.
Proper installation is your responsibility.
Closet door with vents
Recessed area
Closet door with vents
Recessed area
17"
(432 mm)
4"
(102 mm)
14" max.
(356 mm)
3"
(76 mm)
3"
(76 mm)
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
1"
(25 mm)
1"
(25 mm)
3"
(76 mm)
3"
(76 mm)
3"
(76 mm)
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
1"
(25 mm)
1"
(25 mm)
12"
(305 mm)
12"
(305 mm)
INSTALLATION REQUIREMENTS
ELECTRICAL REQUIREMENTS
■ A 120-volt, 60 Hz, AC-only, 15- or 20-amp, fused electrical
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this appliance be provided.
Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation
our products, we reserve the right to change materials and specications without notice. Instructions packed with product. Specications subject to change without notice.