OWNER’S
MANUAL
Date of purchase: _____/ _____/ _____
Saratoga 7 PC
Dining Set
Product code: D71 M80190
UPC code: 7-6945575838-5
1
Vendor Item: SS-J-251-1NT
PARTS
Read through all the instructions before beginning assembly. Unpack and identify all the parts.
Place them on a flat, non-abrasive surface. Assembly by two people is recommended.
ACCESSORIES
2
A (1)
Tempered Glass Tabletop with Rim
(12 Bolts and 12 Metal Washers attached)
B (4)
Leg (2 Bolts and 2 Metal Washers
attached for each leg)
C (1)
Metal Center Ring
D (2)
Support Bar
Ea (1 spare)
Short Bolt
Eb (2)
Long Bolt
Ec (4 + 1 spare)
Metal Washer
Ed (2)
Nut
Ee (1)
Allen Wrench
Ef (1)
Hex Open Wrench
Eg (1)
Assembly Instructions
Sheet
Eh (1)
Umbrella Insert
Ei (1 spare)
Glass Bumper
ASSEMBLY INSTRUCTIONS
Place the tabletop (A) upside down on your
non-abrasive work surface. Remove all bolts and
metal washers from table rim (A) and legs (B).
Attach four legs (B) to the tempered glass tabletop
with rim (A) by inserting a short bolt (Ea) through a
metal washer (Ec), through the leg (B) and secure
into the tabletop rim for each hole. See Fig. 1. Don’t
tighten completely. Repeat procedure for the remaining
three legs.
Place the metal center ring (C) between the four
legs and line up the holes. Insert a short bolt (Ea)
through a metal washer (Ec), through the center
ring (C) and into the leg (B) for each hole. See Fig. 2.
Don’t tighten completely. Repeat procedure for the
holes on the remaining three legs.
Attach a support bar (D) to the tempered glass
tabletop with rim (A) by inserting two short bolts (Ea)
through two metal washers (Ec), through the support
bar (D) and secure into the tabletop rim (A). See Fig. 3.
Line up the holes in the support bar (D) with the
holes in the center ring (C) and from outside insert
a long bolt (Eb) through a metal washer (Ec), through
the support bar (D), through the center ring (C),
through another washer (Ec) and secure with a
nut (Ed). See Fig. 4. Don’t tighten completely. Repeat
procedure for the other support bar (D).
1
2
3
4
3
CARE INSTRUCTIONS
Wash with a mild solution of soap and water; rinse thoroughly. Dry completely. Do not use bleach or solvents.
Cover furniture with outdoor furniture covers when not in use.
Made in CHINA
Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
For questions or comments about product:
Call toll-free:
800-457-4652
Please refer to part numbers when reordering
Securely tighten all bolts and nuts diagonally by using
Allen wrench (Ee). Turn the table over and open hex
wrench (Ef) provided. Place the umbrella insert (Eh)
into the umbrella hole when there is no use of it.
5
Fig. 1
Fig. 2
Fig. 4
Fig. 3
Your table is now ready for use.
Ec
B
Ea
Ea
A
Ec
C
Ed
D
Eb
Ec
Ec
C
Ea
Ec
D
A
B
D
C
A
/