Solar Street Light
User Manual-HY-SW108
Solar Street Light for use of illumination
with excellent energy-saving function
Specifications:
Motion Sensor Solar Light
Lithium iron phosphate
battery 3.2V 4500mAh
SMD 2835 29-30 lm 4000k or
6000k
Sun exposure time is greater
than 8 hours
How to install the device:
Please charge solar light for 6 hours before use
1. Press the button lasting 5 seconds for power on,
and select your desired lighting mode.
2. Nail 2 screws to the wall and hang the product
directly.
Applications:
First, completely shut down the solar panels or put it
down on desktop, then press the button lasting 5
second for starting lamp. Enter into operating mode
after starting. Each press to the button will change
operating modes with light flickering at the same
time. The circulatory switchover of operating mode
is as follows:
1. Micro-mode + Induction mode
When someone comes, the sensor triggers
circuit to start high light, the light will dim after
someone leaving
(First recommended for use)
2. Induction mode
When someone comes, the sensor triggers
circuit to start high light, the light will be turned
off after someone leaves for 15 seconds.
3. Always light mode
It will light all night with no induction mode
(Used in special place)
4. Emergency light mode
Commonly used for emergency lighting like
power failure and night activities. Timing of
emergency light mode is 30 minutes. Solar
panel shall be restarted or illuminated after
lights off.
5. Shutdown
Additional remarks:
1. Attention: the time of sun exposure to solar
panels is closely related to local weather,
installation site and direction, which will directly
influence the charging effect.
2. The service life of lithium iron phosphate
battery is more than 5 years so no need for
replacement during use. The product shall be
disposed appropriately due to internal battery.
Never put it into fire to escape from danger of
explosion.
3. The lampshade may be broken when littered or
dropped due to its raw material of plastic.