Post Shields 11030 Installation guide

Each side has a hook and a arrow

for connection. You can slide or snap

each shield together.

No Screws or Nails

No Tools Needed

This example shows the preferred

method of installation: Snapping the

shields together

Push the arrow side of the shield into

the hook side with some force. You

could use a rubble mallet if needed

You will hear a snap sound when they connect

creating your complete protection around your post.

Assemble 3 shields together

and wrap around the post

Then slide or snap the

last shield into place

If sliding the shields, align the hook and arrow and push

down. There will be some friction and will take some force.

You could use a rubber mallet if needed.

Final top view