2. Home
  3. Domestic appliances
  4. Climate control
  5. Fireplaces
  6. Lopi
  7. 32 DVS Gas Fireplace Insert
32 DVS Gas Fireplace Insert

Lopi 32 DVS Gas Fireplace Insert, 34 DVL Gas Fireplace Insert, 430 Deluxe Gas Fireplace Insert, Answer NexGen-Fyre™ Wood Insert, Medium Flush Wood Hybrid-Fyre® Rect., Radiant Plus Large™ Gas Fireplace Insert, Radiant Plus Medium™ Gas Fireplace Insert Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Lopi 32 DVS Gas Fireplace Insert Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
One-Piece Panel Trim (see part numbers below)
Page 1 of 2 17602091 Printed 9/24/19
Part Numbers & Compatibility
Part Number (sku) Height x Width Compatible Units
96500891 25” x 38”
DVS Insert (96100318)
430 Insert (96100337)
Radiant Medium Insert (96100552)
96500892 28-1/2” x 40”
DVS Insert (96100324)
430 Insert (96100338)
Radiant Medium Insert (96100553)
Answer Wood Insert (96100440)
96500893 30-1/2” x 42”
DVL Insert (96100323)
616 Insert (96100349)
Radiant Large Insert (96100562)
Answer Wood Insert (96100441)
Flush Wood Medium (96100212)
96500894 34” x 44”
DVL Insert (96100319)
616 Insert (96100350)
Radiant Large Insert (96100563)
Flush Wood Medium (96100215)
Installation Sizing
When using this trim, the insert will be located 1-1/4” forward of its standard location
relative to the fireplace (see illustration below). This will position the appliance an extra 1-
1/4” onto the hearth and 1-1/4” less into the fireplace. This will affect fireplace sizing and
hearth requirements (see insert manual for details).
Optional Trim
1-1/4" (32mm)
Surround Panel
One-Piece Panel Trim (see part numbers below)
Page 2 of 2 17602091 Printed 9/24/19
Installation
Install the panel trim as shown below.
Top Trim
"L" Bracket
Right Side Trim
"L" Bracket
Right Side
Trim
Top Trim
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Micro (1/16”)
Standard
Screwdriver
Spring
Clips
Optional Knock-Out
An optional knock-out is provided on both sides if the
power cord is routed behind the surround panel.
/