Rinnai V94EP, your new continuous flow gas hot water system, offers endless hot water for your home. With its impressive capacity to deliver up to 9.8 GPM (37.1 l/min) of hot water, you'll never run out, even during simultaneous use. It boasts energy-saving features like an Energy Factor of 0.82 for both natural gas and propane, helping you save on utility bills.
Rinnai V94EP, your new continuous flow gas hot water system, offers endless hot water for your home. With its impressive capacity to deliver up to 9.8 GPM (37.1 l/min) of hot water, you'll never run out, even during simultaneous use. It boasts energy-saving features like an Energy Factor of 0.82 for both natural gas and propane, helping you save on utility bills.
0.0
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
9.0
10.0
0 25 50 75 100 125 150
Water Flow gpm (l/min)
delta T - Temperature Rise (ºF)
Type of Appliance
Rinnai Model Number
Operation / Installation
Minimum/Maximum Gas Rate (Input)
Electrical
Electrical Consumption
Amperage
Ignition System
Hot Water Capacity
Temperature
Temperature (without remote)
Installation
Energy Factor
Service Connections
Water Flow Control
Minimum/Maximum Water Supply Pressure
Temperature controlled, continuous flow, gas hot water system
Certified for installation in manufactured (mobile) homes
Forced combustion
REU-VC2837W-US
Forced combustion; outdoor only
10,300 - 199,000 BTU/h (3.02-58.3kWh)
Appliance: AC 120 Volts - 60 Hz
Controller: DC 12 Volts
Normal: 65 w Standby: 2 w Anti-frost protection: 104 w
Max : 4A Fuse: 10A
Direct electronic ignition
Minimum flow rate: 0.26 GPM (1 l/min)
Minimum activation flow rate: 0.4 GPM (1.5l /min)
Maximum flow rate: 9.8 GPM (37.1 l/min)
98° - 120°F (37°- 49°C) (factory default) Maximum temperature is selectable
at 120°F (49°C) or at 140°F (60°C) ; 98° - 185°F (37°- 85°C) available with
the MCC-91-2 controller for hydronic applications
120°F (49°C) (factory default) or 140°F (60°C)
Outdoor only
Natural Gas: 0.82 Propane: 0.82
Gas supply: 3/4 inch(19mm) MNPT, Cold water inlet: 3/4 inch(19mm) MNPT
Hot water outlet: 3/4 inch(19mm) MNPT
Water flow sensor, electronic water control device and by-pass
20 - 150 PSI (138-1035 KPa) (recommended 30-80 PSI (209 - 552 KPa) for
optimal performance)
© 2015 Rinnai Corporation
V94e VC SP 8/2015
FLOW TABLE
V94e (VC2837W-US)
Rinnai is continually updating and improving products; therefore, specifications are subject to change without prior
notice. Local, state, provincial and federal codes must be adhered to prior to installation.
Low Lead Content
NSF/ANSI 372
C U
SANITATION
25(13.9) 50(27.8) 75(41.6) 100(55.6) 125(69.4)
150(83.3)
0
6.0 (22.7)
1.0 (3.8)
2.0 (7.6)
3.0 (11.4)
0.0
5.0 (19.0)
4.0 (15.1)
7.0 (26.5)
10.0 (37.9)
9.0 (34.1)
8.0 (30.3)
9.27 (235.5)
22.95 (583)
A
0.28 (7.2)
0.59 (15)
14.04 (356.6)
1.14 (29)
2.23 (56.6)
8.90 (226)
Rinnai Corporation • 103 International Drive • Peachtree City, GA 30269 • Toll-Free: 1-800-621-9419 • Fax: 678-364-8643 • www.rinnai.us
Water Temperature Control
Controller
Controller Cable
Safety Devices
Clearances from Combustibles
Clearances from Non-combustibles
* 24 inches required for serviceability
Min. / Max. Gas Supply Pressure
Manifold Gas Pressure (inches W.C.)
(sea level)
NOx
Simulation feed forward and feedback
MC-91-2US (included)
Deluxe controller: MC-100V-1US (optional)
Bathroom controller: BC-100V-1US (optional)
MCC-91-2US (optional; for hydronic and commercial applications)
Non-polarized two-core cable, minimum 22 AWG
Flame failure - Flame Rod
Boiling protection
Combustion fan rpm check
Over current - glass fuse
Top of heater - 12 inches(305mm)
Front (Panel) - 24 inches(610mm)
Front (Exhaust) - 24 inches(610mm)
Top of heater - 2 inches(51mm)
Front (Panel) - 0 inches *
Front (Exhaust) - 24 inches(610mm)
Natural Gas: min 4” W.C. (10mbar) max 10.5” W.C. (26.1mbar)
Propane Gas: min 8” W.C. (20mbar) max 13.5” W.C. (33.6mbar)
Natural Gas: high fire 2.5” W.C. (6.23mbar) low fire 0.52” W.C. (1.30mbar)
Propane Gas: high fire 4.5” W.C. (11.21mbar) low fire 0.80” W.C. (2.00mbar)
Complies with South Coast Air Quality Management District 14 ng/J or 20 ppm
NOx emission levels
Remaining flame (OHS)
Thermal fuse
Automatic frost protection
Back of heater - 0 inches
Bottom of heater - 12 inches(305mm)
Sides of heater - 6 inches(152mm)
Back of heater - 0 inches
Bottom of heater - 2 inches(51mm)
Sides of heater - 1/8 inch(3.2mm)
V94e (VC2837W-US)
DIMENSIONS
WEIGHT: 44.3 lb (20.1 kg)
B
C
D
E
F
G
DIMEN-
SION
Inches (mm)
DIMEN-
SION
Inches (mm)
A (GAS)
1.31 (33.2)
D
4.33 (110)
A (COLD)
1.93 (49)
E
2.91 (73.8)
A (HOT)
1.35 (34.4)
F
1.61 (40.8)
B
3.96 (100.7)
G
2.87 (73)
C
1.17 (29.8)
Heat exchanger: 10 years* for residential and hydronic applications, increased to 12 years* if
installed with an isolation valve kit; All other parts: 5 years*; Labor: 1 year
(* reduced to 3 years if used as a circulating water heater within a circulation loop, when the water
heater is in series with a circulation system and all circulating water flows through the water heater)
Refer to the manual for complete warranty information.
Limited
Warranty
-
1
-
2
Rinnai V94EP Dimensions Guide
- Type
- Dimensions Guide
- This manual is also suitable for
Rinnai V94EP, your new continuous flow gas hot water system, offers endless hot water for your home. With its impressive capacity to deliver up to 9.8 GPM (37.1 l/min) of hot water, you'll never run out, even during simultaneous use. It boasts energy-saving features like an Energy Factor of 0.82 for both natural gas and propane, helping you save on utility bills.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Rinnai REU-V2520FFUC-US User manual
-
-
-
Rinnai V75EP Specification
-
Rinnai V94iN Specification
-
-
-
Rinnai V65eN-MIVK-T-LW-PCDO3-EWV Specification
-
Rinnai RL75EP Specification
-
Rinnai RL94EP Dimensions Guide