Pull out Kitchen Faucet Installation
1. Remove the locking nut, metal
washer and rubber washer.
2. Install faucet through center hole,
assembly washer and metal washer
on faucet, and tighten with lock nut.
3. Screw and tighten the pull out
hose and weight kit to the faucet .
4. Screw and tighten the hot & cold
flexible hoses to the faucet. Do not
allow the water supply brass tube to
twist.
5. Proper installation of the hose weight kit
will ensure that the spray retracts smoothly.
On the spray side of the hose, measure 15"
down from the body of the faucet. Install the
hose weight kit at this point. Pull out on the
spray. It should move easily and retract
smoothly. Reposition the hose weight kit as
necessary.
6. Attach flexible hose to water
supply.
7. Remove the spray head and
rubble washer. Turn on faucet
handle for 1 minute to flush debris
from faucet. Turn off the faucet, re-
assemble the rubble washer and
spray head.
8. Turn on the handle, press the
top position on button, it will be
spray .
9. Turn on the handle, press the
down position on button, the flow
will come from the middle .