CHARGING
Please make sure the shaver is switched OFF before charging.
Fully charge the shaver for 1.5 hours before first use.
NOTE: Normal charging time of the shaver is 1.5 hours. Do not charge for more than 1.5 hours.
When fully charged, the number display shows 60 and the shaver can continuously works
approx. 60 minutes.
IMPORTANT! Use only with the charger provided, SW-050100AUL.
BATTERY CARE
To ensure maximum life of the rechargeable battery in your shaver, follow these
guidelines:
Do not recharge the shaver between sessions. Wait until the battery exhausted
before recharging.
Discharge the battery completely at least twice a year (switch on and run until the
shaver stops).
If the shaver has not been used for a long period of time, discharge the battery
completely, then fully charge it for 1.5 hours before use.
Never charge the shaver for more than 1.5 hours.
Do not use the shaver while charging.
Do not charge the shaver when the temperature is below 0°C or above 40°C.
Avoid recharging the shaver in direct sunlight or near a radiating heat source.
OPERATING INSTRUCTIONS
NOTES:
Improper handling of the shaver may result in damage to the shaver.
Do not use the shaver for wet shaving.
Do not use shaving gel or shaving cream.
Normal operation
1. Remove the protective cap from the shaver.
2. Press the on/off switch to turn the shaver on.
3. Stretch your skin and shave against the direction of your beard growth.
NOTE: Applying excessive pressure does not provide a closer shave.
4. While applying gentle pressure, move the shaver head in small circular motions.
5. Press on/off switch to turn the shaver OFF.
6. Clean the shaver carefully and place the protective cap on the shaver.
Using the trimmer
1.Push the trimmer release button downwards until the trimmer flip up.
2.Press on/off switch to turn the shaver ON.
3.Slowly guide the trimmer up to the hair you intend to cut. Always use short strokes
to cut your hair. Do not apply too much pressure when using the trimmer. It reduces
cutting performance and may cause skin irritation.
4.Press the On/Off switch to turn the shaver OFF and close the trimmer until you
hear a ‘click’.
NOTE: The trimmer always generates a straight cutting edge. If you do not want a
straight cutting edge, you must hold the shaver at an angle. For hard-to-reach areas
or for very precise cuts, use a comb to check the cut length.