Hearth and Home Technologies WSK-21-W Installation and Operating Instructions

Hearth and Home Technologies
Brand
Hearth and Home Technologies
Model
WSK-21-W
Type
Installation and Operating Instructions
1
Hearth & Home Technologies • WSK-21-W Instructions • 130-900 Rev. K • 1/20
WSK-21-W WALL SWITCH KIT
- Installation And Operating Instructions -
Figure 1.
Check Contents of Shipping Carton
Compare contents of carton in Figure 1 with the actual parts
received. If any parts are missing or damaged, contact
your dealer before beginning installation. DO NOT install
a damaged wall switch kit.
Installation instructions
Installing the Wall Switch
1. Install the wall switch in a convenient location. Run
low voltage, 2-conductor wire from the wall switch into the
base of the appliance.
2. Determine which ignition system is installed on the ap-
pliance using Figures 2, 3 and 4. Connect the 2-conductor
wire accordingly.
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
Installation Precautions
The WSK-21-W Wall Switch Kit is tested and safe when
installed in accordance with this installation manual. It is
your responsibility to read all instructions before starting
installation and to follow these instructions carefully during
installation.
Do not install any components that may be damaged.
Do not modify, disassemble, or substitute any of the
components included with this kit. Installation of this kit
must be done by a qualied service technician.
The wall switch kit is carefully engineered and must be
installed only as specied. If you modify it or any of its
components, you will void the warranty and you may
possibly cause a re hazard.
All wiring should be done by a qualied electrician and
shall be in compliance with local codes and with the
National Electric Code ANSI/NFGA No. 70- current (in the
United States), or with the current CSA C22.1 CANADIAN
ELECTRIC CODE (in Canada).
NOTICE: DO NOT connect 110-120 vac wiring to the gas
control valve of this appliance or to the wall switch for in-
stallation of this kit. Component damage will occur.
WALL
SWITCH
WALL
SWITCH
PLATE
SCREWS
WIRE
CONNECTORS (2)
Preparation
CAUTION! Risk of Burns! The replace should be
turned off and cooled before kit is installed.
Remove decorative barrier front if previously installed.
2
Hearth & Home Technologies • WSK-21-W Instructions • 130-900 Rev. K • 1/20
FLAME
SENSE
IGNITER
ADAPTER
I
S
6 PIN
ORANGE
(PILOT)
GREEN
(MAIN)
RF MODULE
(FOR USE WITH OPTIONAL
REMOTE CONTROL)
ELECTRONIC CONTROL MODULE
VALVE
IFT-RC150
WIRELESS
WALL SWITCH
(OPTIONAL)
IFT-RC400
REMOTE CONTROL
(OPTIONAL)
6V DC
BATTERY PACK
RED
BLK
RED
JUMPER
WIRE
WSK-21-W
WALL SWITCH
BRN
BLK
HOT
NEUTRAL
JUNCTION BOX
110-120 VAC
Figure 2 IntelliFire® Touch Wiring Diagram
Recommended Operating Procedures
1. Follow the lighting instructions section in the appliance
Installation Manual.
2. Turn the wall switch “ON” to light the burner.
3
Hearth & Home Technologies • WSK-21-W Instructions • 130-900 Rev. K • 1/20
Figure 3 Intellire Pilot Ignition (IPI) Wiring Diagram with Wall Switch
TRANSFORMER
3 VAC
PLUG IN
BLACK
RED
BATTERY PACK
WIRES
(TO BROWN)
ORANGE
GREEN
VALVE
WHITE
ORANGE
IGNITION MODULE 3 VAC INTERMITTENT PILOT IGNITOR
HOT
NEUTRAL
I
S
GROUND TO
FIREPLACE
CHASSIS
WSK-21-W WALL
SWITCH
4
Hearth & Home Technologies • WSK-21-W Instructions • 130-900 Rev. K • 1/20
Please contact your Hearth & Home Technologies dealer
with any questions or concerns.
For the location of your nearest Hearth & Home
Technologies dealer,
please visit www.hearthnhome.com.
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com
RC100 (optional)
RC200 (optional)
Valve
Power supply
plugged into
junction box
(110-120 VAC)
Module
Pilot
Assembly
Wiring
harness
Battery
holder
RED
BLK
RED
RED
BRN
BLK
BLK
ORG
GRN
ORG
WHT
Wall
switch
wires
BLK
RED
WHT
RC300 (optional)
WSK-21-W
WALL SWITCH
Figure 3 Intellire Pilot Ignition (IPI) Wiring Diagram with Wall Switch
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Hearth and Home Technologies WSK-21-W Installation and Operating Instructions

Hearth and Home Technologies
Brand
Hearth and Home Technologies
Model
WSK-21-W
Type
Installation and Operating Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents