AWM-LTH Page 1 of 2

Installation Guide

AWM-LTH

Heavy Duty VESA Tilt Head

COMPONENT CHECKLIST

IMPORTANT INFORMATION

! Please ensure this product is installed as per these installation instructions.

! Curvedmonitors,deepdevices(suchasall-in-onePCs)andosetVESAlocationsexertadditionalleveragethatcanexceedthe

capacityofthemounteventhoughthemonitorweightmaybewithinthestatedrange.

monitormountingsolution.

REQUIRED TOOLS

AWM-LTH Page 2 of 2

1. Attach VESA head to monitor

1.2Ensuresuitablescrewsizeisused. 1.3VESAmountingcompatibility

Note: Forothersizes,useasuitable

adaptor plate

1.1ScrewtheVESAheadontomonitor

Note:Alwayssupportthemonitor

whilstadjustingtopreventitfrom

fallingforwardsharply.

2.1 Push tilt head onto the shaft at the

endofthemonitorarm.

2.3 Tightenthejointscrewtosecure

thetiltheadandmonitorinplace.

3. Adjust tilt tension

Note: Check the arm rotation

issmoothaftertightening.

2.2Ensuretiltheadisfullypushed

ontoshaft.