Sunbeam 3932 can be used for various types of fabric as it has a wide selection of temperature settings. It also comes with a shot of steam function for stubborn creases. To help prevent sticking to the fabrics and residue, the device has a nonstick soleplate. The water tank is easy to remove and accepts tap water, eliminating the need for distilled water. Safety features include an automatic shut-off and a polarized plug to reduce the risk of electrical shock. The handle release button collapses and locks the handle for compact storage.
Sunbeam 3932 can be used for various types of fabric as it has a wide selection of temperature settings. It also comes with a shot of steam function for stubborn creases. To help prevent sticking to the fabrics and residue, the device has a nonstick soleplate. The water tank is easy to remove and accepts tap water, eliminating the need for distilled water. Safety features include an automatic shut-off and a polarized plug to reduce the risk of electrical shock. The handle release button collapses and locks the handle for compact storage.
Page is loading ...
When using your iron, basic safety precautions
should
always be followed, including the following:
.
.
.
.
.
.
.
.
.
.
2
BEAD ALL INSTRUCTIONS BEFORE USE.
Use iron only for its intended use.
To protect against risk of electric shock, do not
immerse the iron in water or other liquids.
The iron should always be turned to “OFF” before
plugging or unplugging from outlet. Never yank cord
to disconnect from outlet; instead, grasp plug and pull
to disconnect.
Do not allow cord to touch hot surfaces. Let iron cool
completely before putting away. Loop cord loosely
around iron when storing.
Always disconnect iron from electrical outlet when
filling with water or emptying and when not in use.
Do not operate iron with a damaged cord or if the iron
has been dropped or damaged. To avoid the risk of
electric shock, do not disassemble the iron. Take it to an
authorized service center for examination and/or repair.
Incorrect reassembly can cause a risk of electric shock
when the iron is used.
Close supervision is necessary for any appliance being
used by or near children. Do not leave iron unattended
while connected or on an ironing board.
Burns can occur from touching hot metal parts, hot
water or steam. Use caution when you turn a steam
iron upside down
-
there may be hot water in the
reservoir.
If the iron is not operating normally, disconnect
from the power supply and have the iron serviced
by an authorized service center.
l
Your
SUNBEAM@
Iron is designed to rest on the heel rest.
Do not leave the iron unattended. Do not set the iron
on an unprotected surface, even if it is on its heel rest.
SPECIAL INSTRUCTIONS
l
This is a 400 watt appliance.. To avoid a circuit
overload, do not operate another high wattage
appliance on the same circuit.
l
If an extension cord is absolutely necessary,
a lo-ampere cord should be used. Cords rated
for less amperage may overheat. Care should
be taken to arrange the cord so that it cannot
be pulled or tripped over.
l
This appliance was set at the factory to operate at
120 Volts. Refer to Operating Instructions Section
of this manual for conversion to 240 Volt operation.
l
Be sure dual voltage selector is in the correct voltage
position before operation. Before plugging iron into
outlet, read the information about dual voltage
operation in the “Voltage” section of this manual.
l
To reduce the risk of electrical shock, this appliance
has a polarized plug (one
blade is wider than the
other). This plug fits a polarized outlet only one way;
if the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety feature.
SAVE THESE
INSTRUCTIONS
*
3
Congratulations on Your Purchase of a SUNBEAM@ Iron!
SUNBEAM’
Irons are designed to provide the utmost in quality,
ease of use and convenience.
This
SUNBEAM@
Iron offers the following features:
A. SHOT OF STEAM’
BUTTON
-
for stubborn wrinkles
B. W
ATER
T
ANK
R
ELEASE
BUTTON
-
to easily fill the water tank
C. F
ABRIC
S
ELECT
D
IAL
-
adjusts temperate for various fabric types
D. TANGLE-FREE
CORD
-
keeps the power cord off the fabric
and out of the way
E. V
OLTAGE
SELECTOR
S
WITCH
-
for international travel
F.
H
ANDLE
R
ELEASE
B
AR
-
automatically opens and locks handle
into place
G.
NON-STICK
SOLEPLATE
-
prevents starch residue and fabrics
from sticking
H.
H
ANDLE
R
ELEASE
BUTTON
-
collapses and locks handle
for compact storage
I.
WATER TANK
-
accepts tap water and eliminates
the
need
for distilled water
4
V
OLTAGE
.
Be sure the dual voltage selector is in
the correct position before operating.
In North America the voltage selector switch
should be placed in the 120 volt position.
This appliance was set at the factory to
operate at 120 volts (See Figure
1).
.
*
.
. .
HANDLE
b
c--l
‘SL?
To unlock the handle, press the handle
FIGURE
1
release bar (See Figure 2). The handle
will automatically rise to the upright
position and lock into place.
W
ATER
F
ILL
IMPORTANT: Always turn the fabric
select dial to OFF and disconnect
iron from electrical outlet before
filling or emptying the water tank.
FIGURE 2
Slide the water tank release button backwards (See Figure 3)
and hold into position with one hand. Lift water tank to
remove from iron with the other hand (See Figure 4).
FIGURE 3
0
Lift the fill hole cap on the water tank and
4
b
fill with clean tap water (See
Figure
5).
Replace the fill hole cap, ensuring th
b
it is fastened securely.
Snap the front of the water tank
into the iron base (See Figure 6).
Slide the water tank release button
backwards and hold into position with
FIGURE 5
one hand. Press back of water tank into
position with other hand and release the
button to lock the tank in place.
IRONING
Plug iron into an electrical outlet.
Use the “Fabric Setting” chart to
determine the best setting and method
for the fabric you plan to iron.
FIGURE 6
Move the fabric select dial to the desired setting.
The temperature can be adjusted by turning the dial clockwise
until the indicator mark is aligned with the proper setting.
Allow the iron to heat for approximately five minutes.
While the iron is heating, make sure it is sitting on its
heel rest and handle on a stable, protected surface.
SHOTOFSTEAM'
For particularly stubborn creases, the SHOT OF STEAM@
function can be used if the temperature adjustment dial
is on the hottest setting.
Set the fabric select dial to the “cotton/linen” setting.
Wait for the iron to reach temperature, press the steam button
firmly and release.
6
FABRIC CHART
FABRIC SETTING
IRON RECOMMENDATIONS
Acetate, Nylon, Synthetic
Iron garment inside out
Polyester,
Rayon
while still damp.
Acrylic, Silk Silk
Iron garment inside out.
Wool Wool
Iron garment inside out
or use ironing cloth?
Cotton,
cotton/
Iron dark fabrics inside out to prevent
Cotton blends,
Linen shine marks. Use
S
HOT OF
STEM&
Linen
feature to remove stubborn wrinkles.
*An ironing cloth is a cotton, dry-cleaned cloth that you place over
the garment you are ironing to prevent the fabric from
looking shiny.
CARING FOR YOUR IRON AFTER USE
Turning Off Your Iron
Turn the temperature select dial to OFF. Unplug the iron from
the power source.
Storing Your Iron
l Allow iron to cool. Remove water tank
T
from iron and empty water from fill
hole. Replace water tank.
l Wipe soleplate with a soft, damp cloth
a
F
IGURE
7
to remove residue as required.
l Press handle release button in (See Figure 7) and push handle
down to lock into position.
l Loosely loop the power cord around iron and store iron in
the travel pouch.
Sunbeam Products, Inc. (“Sunbeam”) warrants that for a period of one year from the
date of purchase, tbii product will be free from defects in material and workmanship.
Sunbeam, at its option, will repair or replace tbii product or any component of the
product found to be defective during the warranty period. Replacement will be made
with a new or remanufactured product or componmt. If the product is no longer
available, replacement may be made with a similar product of equal or greater value.
This is
your exclusive warranty.
This warranty is valid for the original retail purchaser from the date of initial retail
purchase and is not transferable. Keep the original sales receipt. Proof of purchase is
required to obtain warranty performance. Sunbeam dealers, service centers, or retail
stores selling Sunbeam products do not have the right to alter, modify or in any way
change the terms or conditions of this warranty.
This warranty does not cover normal wear of parts or damage resulting from any of
the following: negligent use or misuse of the product, use on improper voltage or
current, use contrary to the operating instructions, disassembly, repair or alteration
by anyone other than Sunbeam or an authorized service center. Further, the warranty
does not cover acts of nature, such as fire, flood, hurricanes and tornadoes.
Sunbeam shall not be liable for any incidental or consequential damages caused by
the breach of any express or implied warranty. Except to the extent prohibited by
applicable law, any implied warranty of merchantability or fitness for a particular
purpose is
limited
in duration to the duration of the above warranty. Some states,
provinces or jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages or limitation on how long an implied warranty lasts, so the
above
limitations
or exclusion may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights that vary from state to state or
province to province.
How to Obtain Warranty Scrvice
Take the product to an authorized Sunbeam service center. You may obtain a list of
service centers and other repair/replacement instructions by calling: 1800 458-8407 or
send an e-mail to:
Please include name,
address, telephone number, product model number and description of the problem.
DO NOT RETURN THIS PRODUCT TO THE PLACE OF PURCHASE
For product questions contact:
Sunbeam Consumer Service
F! 0. Box 948389
Maitland, FL 32794-8389
Do not send product to the above address.
www.sunbeam.com
Made in China P.N. 107279
8
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
02001 Sunbeam Products, Inc. All rights reserved.
SUNBEAM*
and
SHOT
OF
Sm8
are registered trademarks of Sunbeam Products, Inc.
Printed in China.
02001 Sunbeam Products, Inc. Todos los derechos reservados.
SmW
y
SHOT
OF
SW
son marcas registradas de Sunbeam Products, Inc.
Impreso en China.
Made
in
China
P.N.
107279
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
Sunbeam 3932 can be used for various types of fabric as it has a wide selection of temperature settings. It also comes with a shot of steam function for stubborn creases. To help prevent sticking to the fabrics and residue, the device has a nonstick soleplate. The water tank is easy to remove and accepts tap water, eliminating the need for distilled water. Safety features include an automatic shut-off and a polarized plug to reduce the risk of electrical shock. The handle release button collapses and locks the handle for compact storage.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- español: Sunbeam 3932 Manual de usuario
