21
4) CLEANING AND MAINTENANCE
a) Cleaning the liquidizer
Note: It is necessary to use the spanner (9) for remove the blade unit: screw clockwise, then
pull off the blade unit easily.
2. Clean these parts with the cleaning brush in warm water with some washing-up liquid
and rinse them under the tap.
3. Clean the motor base with a dry cloth. Do not submerge the motor base in water or in
any other liquid, and do not place it under the tap.
You can clean the glass jug automatically if you wish. Put water and a little detergent into the
jar and press the "Clean/Pulse" button. The jar will be cleaned automatically.
It may also be washed in the dishwasher.
Avoid touching the sharp blades, especially when the appliance is
plugged in. The glass jar should not be subject to large
temperature.variations.
b) Caring for the liquidizer
1. Store the appliance in a dry environment.
2. Never put the jar, or any other parts, in a microwave oven.
c) Troubles shooting
1. If, during use, the product is subjected to such abnormality as noise, smell, smog and
increased temperature, disconnect the power supply and stop the use.
2. In case the appliance fails to work, please check whether the power supply is properly
connected, whether the switch is rotated to the on position and whether the fittings are
in place.
3. If the appliance can not still function well after the above in actions, consult the after sale
service of your retailer.
The appliance is easier to clean if you do so immediately after
use.
1. Unplug the appliance, remove the jar, remove the blending
blade assembly from the jar by carrying out the assembly
procedure in reverse order (see the section "2/ C. Assembling
the blender")