Samsung SF-5800 User manual

Laser Facsimile

User’s Guide

Setup and Operation

SF-5800/SF-5800P

P/N: JC68-00041A Rev.3.00

Internet Home Page:

http://samsungelectronics.com

ELECTRONICS

Trademarks

¥ Windows is a trademark of Microsoft Corporation.

¥ IBM is a trademark of International Business Machines.

¥ Centronics is a trademark of Centronics Data Computer.

¥ Other names and trademarks mentioned in this manual are trademarks of their respective

holders.

i

Contents

Set Up Your Machine _______________________________ 1.2

Unpacking _________________________________________ 1.2

Control Locations and Functions ______________________ 1.3

Front View ______________________________________ 1.3

Rear View _______________________________________ 1.4

Inside ___________________________________________ 1.4

Choosing a Location _________________________________ 1.5

Setting Up Your Machine _____________________________ 1.5

Document Tray ___________________________________ 1.5

Document Exit Tray _______________________________ 1.5

Printer Exit Tray __________________________________ 1.6

Telephone Line ___________________________________ 1.6

Extension Phone __________________________________ 1.7

AC Power Cord __________________________________ 1.7

Printer Cable _____________________________________ 1.8

Installing the Image Cartridge ________________________ 1.9

Loading Paper ______________________________________ 1.11

Using the Automatic Paper Feeder __________________ 1.11

Using the Manual Feeder __________________________ 1.14

Paper Guidelines ____________________________________ 1.15

System Setup _______________________________________ 1.16

Ringer Volume ___________________________________ 1.16

Home Resolution and Home Contrast _______________ 1.16

Sound Control ___________________________________ 1.18

Remote Diagnosis Protection _______________________ 1.18

Select Language __________________________________ 1.19

Econo Mode Setting ______________________________ 1.19

Adjusting Speaker Volume ___________________________ 1.20

Setting the Date and Time ____________________________ 1.21

Setting the System ID (Your Number and Name) _____________ 1.22

Chapter 1 Getting Started

ii

Using the Control Panel ______________________________ 2.2

Using the Number Keypad ___________________________ 2.4

Entering Alphanumeric Characters __________________ 2.4

Entering Numbers ________________________________ 2.6

Editing Numbers or Name _________________________ 2.6

Inserting Pause ___________________________________ 2.6

Sending a Fax ______________________________________ 2.7

Preparing Documents for Faxing or Copying ___________ 2.7

Setting Document Resolution and Contrast _____________ 2.8

Resolution _______________________________________ 2.8

Contrast _________________________________________ 2.8

Loading Document __________________________________ 2.9

Sending a Fax Automatically _________________________ 2.10

Canceling Transmission ____________________________ 2.10

Confirming Transmission __________________________ 2.10

Automatic Redial __________________________________ 2.11

Voice Request _______________________________________ 2.12

Sending a Voice Request ___________________________ 2.12

Answering a Voice Request _________________________ 2.12

Delayed Transmission _______________________________ 2.12

Memory Transmission (Broadcasting) ____________________ 2.14

Priority Transmission ________________________________ 2.15

Adding Documents To a Standby Operation ____________ 2.16

Canceling a Standby Operation _______________________ 2.16

Receiving a Fax _____________________________________ 2.17

Receiving Automatically in FAX Mode _________________ 2.18

Receiving Manually in TEL Mode _____________________ 2.19

1 Getting Started

2 Operation

3 Troubleshooting

Appendix

Chapter 2 Operation

iii

Receiving Automatically in ANS/FAX Mode ___________ 2.19

If Your Machine is Out of Paper

When it Receives a Fax-Receiving into Memory _______ 2.20

Distinctive Ring Pattern Detection (DRPD) ___________ 2.20

Polling _____________________________________________ 2.21

What is Polling? __________________________________ 2.21

Being Polled By a Remote Machine __________________ 2.21

Adding Documents To the Job to be polled ___________ 2.22

Polling One or More Remote Machines ______________ 2.23

Making a Copy _____________________________________ 2.25

Automatic Dialing __________________________________ 2.27

One-Touch Dialing __________________________________ 2.27

Storing a Number for One-Touch Dialing ____________ 2.27

Sending a Fax Using a One-Touch Number __________ 2.28

Using Address Label ______________________________ 2.28

Speed Dialing _______________________________________ 2.29

Storing a Number for Speed Dialing ________________ 2.29

Sending a Fax Using a Speed Number _______________ 2.29

Group Dialing (for Multi-Address Transmission) ________ 2.30

Storing One-Touch or Speed Dial Numbers for

Group Dialing ___________________________________ 2.30

Storing a Group into a One-Touch Button ____________ 2.31

Sending a Fax Using Group Dialing

(Multi-Address Transmission) ______________________ 2.31

Searching for a Number in Memory ___________________ 2.32

Searching Sequentially through Memory ____________ 2.32

Searching for a Particular First Letter _______________ 2.32

Chapter 2 Operation (Continued)

Other Functions ____________________________________ 2.33

Using Function Buttons ______________________________ 2.33

Redial ___________________________________________ 2.33

Recall ___________________________________________ 2.34

Chain Dialling ___________________________________ 2.34

Status ___________________________________________ 2.34

Printing Reports ____________________________________ 2.35

User Options _______________________________________ 2.37

Setting an Option _________________________________ 2.37

Selectable Options ________________________________ 2.37

Maintenance ________________________________________ 2.42

Cleaning Drum ___________________________________ 2.42

Adjusting Shading ________________________________ 2.42

iv

FCC Regulations ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.2

Canadian Radio Interference Regulations ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.2

EC Declaration of Conformity ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.3

Laser Safety Statement ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.4

Safety Information ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.5

Power Saver

ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.6

Specifications ÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐÐ 4.7

Troubleshooting ____________________________________ 3.2

Clearing Jams _______________________________________ 3.2

Document Jams While Sending a Fax _______________ 3.2

Paper Jams While the Machine is Printing ____________ 3.3

Tips for Avoiding Paper Jams _______________________ 3.5

LCD Error Messages _________________________________ 3.6

Fixing Problems _____________________________________ 3.8

Fax Problems _____________________________________ 3.8

Maintenance _______________________________________ 3.10

Clearing Memory ___________________________________ 3.10

Cleaning the Document Scanner ______________________ 3.11

Managing Image Cartridge ___________________________ 3.13

Expected Cartridge Life ___________________________ 3.13

Replacing Image Cartridge ________________________ 3.13

Chapter 3 Troubleshooting

Appendix

v

Important Safety Information

Always be careful when using the machine. To reduce the risk of fire, electrical shock,

and other injuries, keep these safety considerations in mind when installing, using,

and maintaining your machine:

¥ Stability. Place the machine on a secure, stable surface. The machine can cause serious

damage if it falls.

¥ Power Supply. Provide the correct power to the machine, as listed on its back. If you

arenÕt sure of the type of power thatÕs supplied to your home or office, call your electric

company.

¥ Grounding. If the plug has three prongs, it must be plugged into a grounded (three

hole) outlet. Grounded plugs and outlets are designed for your safetyÐdonÕt try to make

a three-prong plug fit into a two-prong outlet by modifying the plug or outlet in any

way. If you canÕt insert the plug into your wall outlet easily, the outlet should be

inspected by a qualified electrician.

¥ Overload. DonÕt plug too many electrical devices into a wall outlet or extension cord.

An overloaded outlet is a fire and electrical shock hazard.

¥ Cleaning. Before cleaning the machine, unplug it from both the power outlet and the

telephone jack. Clean exposed parts with a soft cloth slightly dampened with water.

DonÕt use aerosol cleaners.

¥ Thunderstorms. Unplug electrical appliances during thunderstorms. Avoid using any

telephone (except a cordless model) during a thunderstorm, since thereÕs a small chance

you could get an electrical shock from lightning.

¥ Gas Leaks. Never use any telephone close to a gas leak. If you think gas is leaking, call

the gas company immediately, but use a telephone far away from the leak area.

A small electrical spark in the telephone could cause a fire.

vi

Getting Started

1

1.1

1.2

Set Up Your Machine

Unpacking

Set Up Your

Machine

Toner cartridge

(Part Number :

SF-5800D5/SEE)

Document tray

CD-ROM

(SF-5800P Only)

UserÕs Guide

(Setup and Operation)

Tam/Modem Lead

(Part Number : JC39-00008A )

UserÕs Guide

(Application-

SF-5800P Only)

Printer exit tray

Document exit tray

01 02 03 04 05

06 07 08 09 10

11 12 13 14 15

16 17 18 19 20

Telephone/Modem line cord *

1

(Part Number : JC39-00007A )

One-touch Label

Printer Cable

(SF-5800P Only)

*

1

The shape of power and telephone line cord plugs may differ, depending on your country.

Note: For correct operation the supplied Tam lead and Telephone line cord should be used.

AC power cord *

1

1.3

Set Up Your Machine

Control Locations and Functions

Take a moment to familiarize yourself with the main components and

understand their functions.

Front View

Paper Extension

Automatic Paper Feeder

Manual Paper Feeder

Document Guides

Paper Guides

Document Tray

Control Panel

Document

Exit Tray

Print Exit Tray

1 Getting Started

Note: Your machine may look slightly different than the illustration.

1.4

Set Up Your Machine

Printer Connector

Power Cord Connector

TEL LINE Jack

EXT. LINE Jack

Image Cartridge

Cover

Cover Release Buttons

(right and left)

Rear View

Inside

1.5

Set Up Your Machine

1 Getting Started

Choosing a Location

To help guarantee trouble-free operation of your machine, place it on a

flat, stable surface near your workstation. Leave enough space to allow

for easy paper loading, paper out and opening the front cover.

Do not place your machine:

- In direct sunlight.

- Near heat sources or air conditioners.

- In dusty or dirty environments.

Setting Up Your Machine

Document Tray

Insert two tabs on the tray into the slots as shown. Fold out the

extender on the tray, if necessary.

Document Exit Tray

Insert the two tabs on the document exit tray into the slots on the

front of your machine. Fold out the extender, if necessary.

Extender

Insert one end first, then the other end by pulling this

leg inward to make the tray easy to insert.

1.6

Set Up Your Machine

Printer Exit Tray

Holding the flexible side end, insert two tabs on the side ends into

the corresponding slots. Fold out the extender, if necessary.

Extender

Telephone Line

Plug one end of the telephone line cord into the TEL LINE jack and

the other end into a standard phone wall jack.

TEL LINE

EXT. LINE

1.7

Set Up Your Machine

1 Getting Started

Extension Phone

If you want to use a regular phone or answering machine with your

machine, connect the phone into the EXT.LINE jack.

Plug the cord of your extension phone or answering machine into the

socket marked EXT.LINE on the back of the machine.

TEL LINE

EXT. LINE

AC Power Cord

Plug one end of the cord into the back of the machine and the other

end into a standard AC power outlet.

The machine turns on. If there is no cartridge installed, or no paper, the

display shows ÔDOOR OPEN OR NO TONERÕ or [NO PAPER].

If you want to turn it off, unplug the power cord.

1.8

Set Up Your Machine

Printer Cable

(SF-5800P only)

Your Machine has a parallel interface port, which allows you to use it

with IBM PCs and compatible computers. You have to purchase a

Centronics parallel interface cable that supports bi-directional

communications (IEEE standard 1284). Ask your dealer for assistance if

you need help selecting the right cable.

To connect the printer to the computer, follow the steps below:

1. Make sure that both the machine and the computer are turned off.

2. Plug the cable into the connector on the back of the machine. Push

the metal clips down to fit inside the notches on the cable plug.

3. Connect the other end of the cable to the parallel interface port on

your computer. See your computer documentation if you need help.

1.9

Set Up Your Machine

1 Getting Started

Installing the Image Cartridge

1. Pulling the cover release button toward you, open the cover.

2. Unpack the image cartridge, then carefully remove the sealing tape.

3. Shake the cartridge from side to side 5 or 6 times to distribute the

toner evenly inside the cartridge.

1.10

Set Up Your Machine

4. Find the cartridge slots inside the printer, one on each side.

6. Close the cover. Make sure that the cover is securely closed.

5. Grasp the handle and slide the cartridge down between the

cartridge slots, until it drops into place.

1.11

Set Up Your Machine

1 Getting Started

Extender

Automatic feeder

Manual feeder

Loading Paper

For best results, use high quality xerographic copier paper.

Using the Automatic Paper Feeder

You can stack paper, envelopes, card stocks, labels, or transparencies in

the automatic paper feeder to feed automatically. The automatic feeder

can hold a maximum of 150 sheets of plain paper, and 5 envelopes or

other print media. The maximum capacity may reduce, depending on

the thickness.

Note: If you experience feeding problems, try printing one at a time from the

manual feeder. See page 1.14.

1. Pull the extender on the automatic paper feeder all the way up.

2. Prepare the print material for loading.

¥ For paper and envelopes:

- Flex paper or fan envelopes back and forth. Do not fold or crease

the paper. Straighten the edges on a level surface.

Note: If envelopes jam while printing, try reducing the number of envelopes in

the automatic feeder.

Page is loading ...

Samsung SF-5800 User manual

Samsung SF-5800 User manual

Related papers

Other documents