DX-SF128
4-Outlet 2-USB Power Hub
QUICK SETUP GUIDE
Congratulations on your purchase of this Dynex Power Hub.
Features
• Two USB charging or power ports, 2.1A total charge
current—Fast charging for two smartphones or one tablet.
Using your power hub
1 Plug the Power Hub into the upper outlet of a standard
120V AC outlet, with the plastic plug in the ground jack of the
lower outlet.
2 Plug the power cords from up to four devices into the AC outlets
on the power hub.
3 The USB ports can be used to charge or power certain USB
devices.
Specifications
• Dimensions (L×W×D): 4.8" × 3.1" × 1.4" (not including plug)
(123 × 79 × 35 mm)
Electrical specications:
• Load rating: 15 amps
• Line voltage: 125V AC @ 60 Hz
Plastic plug
Before using your new product, please read these instructions to prevent any damage.
USB ports
AC outlets
V1 ENGLISH 13-0351
Safety precautions
• RISK OF ELECTRIC SHOCK - Use only in dry locations and only
indoors.
• DO NOT plug into another relocatable power tap.
• DO NOT use with any aquarium equipment.
• DO NOT use if correctly grounded outlets are not available.
• DO NOT install this device if there is not at least 30 feet
(10 meters) or more of wire between the electrical outlet and
electrical service panel.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
90-day limited product warranty
Visit www.dynexproducts.com or call 800-305-2204 for additional
product warranty information or for customer service.
Contact Dynex
For customer service call 1-800-305-2204
www.dynexproducts.com
DYNEX is a registered trademark of BBY Solutions, Inc. Registered in some
countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield,
MN 55423 U.S.A.
©2013 BBY Solutions, Inc. All Rights Reserved.
/