Better Music Builder VM-22 Owner's manual

Category
Video switches
Type
Owner's manual
VHF Wireless Microphone System
VM-22
Operating Instructions
Thank you for purchasing this
unit. To make full and effective
use of this unit, please read this
Owner's Manual carefully
before operating it. After
reading this manual, retain this
booklet together with the
Warranty Card for future use
in case of maintenance or
troubleshooting.
Passionate about Music
www.BetterMusicBuilder.com
POWER
VHF Wireless Receiver
POWER
VOLUME
VOLUME
RF
AF
AF
RF
ON
MUTE
OFF PWR
LOW BAT
ON
MUTE
OFF PWR
LOW BAT
TM
®
POWER
ON
DC 12.5-18.OV
OFF
BALANCEDUNBALANCED
RISK OF ELECTRIC SHOCK
Model: VM-22
CALIFORNIA, UNITED STATES OF AMERICA
COMMENTS?
www.BetterMusicBuilder.com
ENGINEERED AND DESIGN IN U.S.A.
Better Music Builder
®
TM
VHF Wireless System
Your Ultimate Choice
Channel-A Volume
POWER RF AF
0 20
12
14
16
18
8
10
2
4
6
Channel-B Volume
0 20
12
14
16
18
8
10
2
4
6
AF RF POWER
Channel-A Volume
POWER RF AF
Channel-B Volume
Your Ultimate Choice
AF RF POWER
Better Music Builder
®
TM
Rear view
1. Channel-A AF volume adjust output jacks +/-15KHz.
2. Channel-A Power.
3. RF Peak indicators (Channel-A).
4. AF Peak indicators (Channel-A).
5. AF Peak indicators (Channel-B).
6. RF Peak indicators (Channel-B).
7. Channel-B Power.
8. Channel-B AF volume adjust output jacks +/-15KHz.
9. Mixed channels 1/4-inch unbalance audio output connector.
10. Mixed channels XLR balance audio output 50Hz~15KHz +/-3dB.
11. Power switch On/Off.
12. Docking power supply with removable IEC cable 12.5-18.0 V.
2
Top view
1 82
9 11 1210
3 4 5 6 7
VM-22 Receiver Features and Controls (Figure 1)
ON
MUTE
OFF PWR
LOW BAT
ON
MUTE
OFF PWR
LOW BAT
9 V
ALKALINE
BATTERY
FREQUENCY:
TRANSMITTER
Better Music Builder
VM-22 Transmitter Features and Controls (Figure 3)
3
13. Rugged unidirectional dynamic element.
14. Easily-accessible power switch On/Off.
15. Indicates low battery
16. Transmitter On and Mute switch.
17. Variable battery cover.
Battery condition Indicator: After battery is
installed, turn the power on. The battery
condition indicator signal light should flash
once. If it does not, the battery is installed
incorrectly or it is dead. If the indicator
signal light stays on (does not flash), the
battery voltage is low and the battery
should be replaced. If this happens during
use, replace (or recharge) the battery
immediately to ensure continued operation.
Transmitter power switch (On/Off)
13 14 1615
17
ON
MUTE
OFF PWR
LOW BAT
VM-22 Handheld Transmitter (Figure 2)
Handheld Transmitter Channel A (Figure 4)
Handheld Transmitter Channel B (Figure 5)
4
Make sure that you insert the battery at the right electric poles.
9 V
ALKALINE
BATTERY
Make sure that you insert the battery at the right electric poles.
9 V
ALKALINE
BATTERY
ON
MUTE
OFF PWR
LOW BAT
9 V
ALKALINE
BATTERY
FREQUENCY:
TRANSMITTER
Better Music Builder
ON
MUTE
OFF PWR
LOW BAT
9 V
ALKALINE
BATTERY
FREQUENCY:
TRANSMITTER
Better Music Builder
POWER
ON
DC 12.5-18.OV
OFF
BALANCEDUNBALANCED
RISK OF ELECTRIC SHOCK
Model: VM-22
CALIFORNIA, UNITED STATES OF AMERICA
COMMENTS?
www.BetterMusicBuilder.com
ENGINEERED AND DESIGN IN U.S.A.
Better Music Builder
®
TM
VM-22 VHF Wireless System Chart (Figure 6)
Audio Cable Balance
(Figure 7)
Audio Cable Unbalance
(Figure 8)
Channel A Handheld Transmitter
Audio Mixer Amplifier or a Karaoke Unit Input terminal
Rear View
120V AC Adaptor
Channel B Handheld Transmitter
5
XLR
Balance Input
XLR
Balance Input
XLR
Balance Input
XLR
Balance Input
1/4"
Unbalance Input
1/4"
Unbalance Input
1/4"
Unbalance Input
1/4"
Unbalance Input
RING (COLD)
TIP (HOT)
SLEEVE (SHIELD)
SLEEVESLEEVE TIP
TIP
1
SHID
COLD
HOT
2
3
1
2
3
SHIELD
COLD
HOT
2
1
3
SHIELD
COLD
HOT
BALANCE XLR CONNECTORS
UNBALANCE XLR CONNECTORS
Balance Connection
ON
MUTE
OFF PWR
LOW BAT
ON
MUTE
OFF PWR
LOW BAT
Audio connect to Amplifier
TV/Video Monitor
Video connect to
POWER
ON
DC 12.5-18.OV
OFF
BALANCEDUNBALANCED
RISK OF ELECTRIC SHOCK
Model: VM-22
CALIFORNIA, UNITED STATES OF AMERICA
COMMENTS?
www.BetterMusicBuilder.com
ENGINEERED AND DESIGN IN U.S.A.
Better Music Builder
®
TM
6
DVD
DVD Karaoke Player
MIC 1 MIC 2
Rear View
Unbalance Connection
VM-22 Basic Karaoke Connection Diagram (Figure 9)
Channel A Handheld Transmitter Channel B Handheld Transmitter
ON
MUTE
OFF PWR
LOW BAT
ON
MUTE
OFF PWR
LOW BAT
RF Carrier Frequency Range
169.445 to 221.350 MHz
Working Range
100 ft under typical conditions.
Audio Frequency Response
50 to 15,000 Hz, +/-2 dB
Audio Output Level (+/-15 kHz deviation, 1 kHz tone)
1/4~inch connector (into 3 k Ohm load): -8.8 dBV (Hi Z)
1/4~inch connector (into 3 k Ohm load): -18 dBV (mix)
RF Power Output: about 30 mWatt
Battery Size: 9V rechargeable
Receiver Dimensions: 220mm(L)x130mm(D)x40mm(H)
Handheld Transmitter Dimensions: 240mm(L)x55mm(H)x30mm(W)
Net Weight: 2 lbs
Specifications
7
Caution: To reduce the risk of electrical shock, do not
remove the cover (or back). No user serviceable parts
inside: refer servicing to qualified personnel.
Warning: To reduce the risk of fire or electrical shock,
do not expose this appliance to rain or moisture.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol, wherever it appears, alerts
you to the presence of uninsulated
dangerous voltage inside the enclosure
voltage that may be sufficient to constitute
a risk of shock.
This symbol, wherever it appears, alerts
you to important operating and
maintenance instructions in the
accompanying literature. Read the
manual.
WARRANTY
One-Year Limited Warranty for Home Use Equipment
Our one-year warranty applies to speakers, amplifiers, mixers and microphones for
home use only. It covers both parts and labors. The warranty becomes effective from
the date of your purchase for one year.
Our warranty only covers defects due to product defectiveness with free of defects in
materials or workmanship. However, our warranty does not cover defects due to
normal wears, damage in transit, improper use, abuse or failure to follow the proper
instructions for maintenance. This warranty is void in the event of unauthorized repairs,
alternations, modifications and removing of the product label.
Please also note that our warranty does not cover any shipping cost for the return of
defective products to us for inspection, repair and maintenance. Our warranty for
Better Music Builder products can only be executed in North America.
Our warranty does not cover the battery for wireless microphone products.
90-Day Limited Warranty for Public and Commercial Use Equipment
Our 90-day warranty applies to speakers, amplifiers, mixers and microphones for
both public and commercial use such as restaurant, coffee shop, KTV nightclub,
church and school, etc. It covers both parts and labors. The warranty becomes
effective from the date of your purchase for 90 days.
To Register Your Warranty
Please fill out the warranty card that came with your unit, download or submit online
warranty form. However, we need the invoice for your purchase in order to process
this warranty. You may also register your warranty online.
Please visit our website at www.bettermusicbuilder.com.
1. If you want to use more than one of this system, please select the work frequency
(or signal channel) carefully so as to avoid disturbing.
2. The input power voltage of the receiver is 120V (±10%). If it is too low or too
high, it will affect the work of the machine.
3. When you install the battery, you must not reverse the electrode or you will
damage the machine.
4. When using the sensitivity solution function, the numerical value you select must be
at least 15dB. Otherwise, if the distance is too far, its signal-to noise radio goes
worse.
NOTE
Warranty
Precaution
Printed on 100% Recycled Paper ©2007 Better Music Builder (USA) Comments E-mail to [email protected] All Rights Reserved in USA.
Passionate about Music
www.BetterMusicBuilder.com
TM
®
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Better Music Builder VM-22 Owner's manual

Category
Video switches
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI