Chief FVS100 Installation guide

Chief
Brand
Chief
Model
FVS100
Category
Mounting kits
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
FVS100
FVS150
Lower Video Conference Camera Shelf
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
FVS100 / FVS150
FVS100 / FVS150 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the FVS100/FVS150 does not
exceed 10 lbs (4.5 kg).
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Installation Instructions FVS100 / FVS150
3
DIMENSIONS
11.34
288
88.9
3.50
13.56
MINIMUM
EXTENSION
344.5
3.50
88.9
19.69
MAXIMUM
EXTENSION
500.1
11.9
1.60
40.8
.47
5.40
308.3
12.14
22.2
.88
13.2
335.3
USABLE SHELF DEPTH
11.2" - SCREEN DEPTH
WEIGHT CAPACITY 10 LBS.
27.3
3.50
88.9
203.2
2.00
50.8
50.8
8.00
2.00
.28
7.1
1.07
5.57
141.6
CENTERLINE OF
MOUNT
FVS100
3.5
89
19.69
MAXIMUM
EXTENSION
500
89
3.5
13.64
MINIMUM
EXTENSION
346
USABLE SHELF DEPTH
11.2" - SCREEN DEPTH
WEIGHT CAPACITY 10 LBS.
101
3.96
137
5.40
1.60
41
2.00
88.9
305
6.00
12.00
152
.28
3.50
7
51
127
5.00
141.6
5.57
1.07
27.3
CENTERLINE OF
MOUNT
16.19
411
19.14
486
13.2
256
335
16
.61
10.06
53
2.07
13.01
331
2.00
51
FVS150
FVS100 / FVS150 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
#2
E (4)
10-24 x 5/8"
F (2)
10-24 x 1"
A (1)
B (1)
C (1)
[FVS100 only]
D (1)
[FVS150 only]
Installation Instructions FVS100 / FVS150
5
Assembly and Installation
Assembling Shelf and Brackets
1. Attach lower shelf (C or D) to hanger bracket (B) using four
10-24 x 5/8" Phillips pan head screws (E). (See Figure 1)
Figure 1
Attaching to Wall Mount
NOTE: The FVS100/FVS150 may be attached to the wall
mount with the display already in place, or with the
display removed. Proceed to either Installing to Wall
Mount with Display Attached or Installing to Wall
Mount with Display Removed section.
Installing to Wall Mount with Display Attached
1. Pull out bottom of display.
2. From below and behind the display, raise and hang hook
bracket (A) onto lower wall mount rail. (See Figure 2)
Figure 2
3. Hang shelf with hanger bracket onto the hook bracket (A).
(See Figure 3)
NOTE: The shelf with hanger bracket may be adjusted up or
down on the hook bracket (A) in 7/8" increments for a
total height adjustment of up to 6.05".
Figure 3
NOTE: Proceed to Installing Camera section.
Installing to Wall Mount with Display Removed
NOTE: Installing the FVS100/FVS150 to a wall mount where a
display has been removed allows use of security
screws to prevent the FVS100/FVS150 from being
removed.
1. Hang shelf with hanger bracket onto the hook bracket (A).
(See Figure 4)
[FVS100 shown]
1
(B)
(E) x 4
(C)
(A)
[Display shown removed for clarity]
Wall Mount
(A)
[Display shown removed for clarity]
FVS100 / FVS150 Installation Instructions
6
Figure 4
NOTE: The shelf with hanger bracket may be adjusted up or
down on the hook bracket (A) in 7/8" increments for a
total height adjustment of up to 6.05".
2. Remove display if already attached to wall mount following
instructions included with the wall mount.
3. Hang FVS100/FVS150 on lower wall mount rail.
4. Adjust location and secure to wall mount rail using two
10-24 x 1" Phillips pan head screws (F). (See Figure 5)
Figure 5
5. Hang display on wall mount following installation
instructions included with the wall mounts.
Installing Camera
1. Install camera to shelf.
NOTE: If camera has a bottom mounting screw, attach it
through the mounting slot in the shelf. (See Figure 6)
2. Route cable from camera. (See Figure 6)
NOTE: Cable may be routed using the cable clip on the
underside of the shelf. Secure the cable at the cable
clip with a wire tie (not included). (See Figure 6)
Figure 6
1
(A)
Shelf with
hanger
bracket
[FVS100 shown]
(F) x 2
4
Cable Clip
Routing Cable
Camera Mounting Slot
Installation Instructions FVS100 / FVS150
7
FVS100 / FVS150 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Room 24F, Block D, Lily YinDu International Building
LuoGang, BuJi Town, Shenzhen, CHINA.
P +86-755-8996 9226
F +86-755-8996 9217
Chief Manufacturing, a products division
of Milestone AV Technologies
8807-000081 Rev01
2009 Milestone AV Technologies,
a Duchossois Group Company
www.chiefmfg.com
01/09
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief FVS100 Installation guide

Chief
Brand
Chief
Model
FVS100
Category
Mounting kits
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents