DURAWATT
®
CL
COMMERCIAL ELECTRIC WATER HEATER LIGHT DUTY
Cold Inlet 3/4"
and Drain
Electrical
Connection
H
W
Lower Heating
Element Housing
Upper Heating Element
and Hi-Limit Housing
Temperature and
Pressure Relief Valve
Hot Outlet 3/4"
(extends 1-1/2 inches
from top of tank)
Model Number Storage
Capacity
KW
GPH Recovery
40º to 120ºF
H
Height
W
Width
Shipping
Weight lbs.
8 C 10-E 10 1.5 8 21 20 110
16 C 10-E 10 3 16 21 20 110
8 C 19-E 19 1.5 8 33 20 151
16 C 19-E 19 3 16 33 20 151
* C 30-E 30 see below see below 41 20 180
* C 40-E 40 see below see below 58 20 245
* C 41-E 40 see below see below 33 26 245
* C 50-E 50 see below see below 51 22 255
* C 51-E 50 see below see below 36 28 255
* C 60-E 60 see below see below 58 22 300
* C 65-E 65 see below see below 48 26 325
* C 70-E 70 see below see below 69 22 330
STANDARD EQUIPMENT and FEATURES
• Rotationally molded cement tank lining
• No anode rods required
• Non-ferrous tank fittings
• 150 psi design pressure, 300 psi test pressure
• Relief valve set for 210ºF and 150 psi
(field installed)
• Dual copper-sheathed heating elements with
individual thermostats adjustable to 125ºF *
• Manual-reset high limit control set at 190ºF
• 2" foam insulation
• Composite jacket
• Drain valve
• 5-year non-prorated tank warranty
PVI INDUSTRIES, LLC ▪ FORT WORTH, TEXAS ▪ (800) 784-8326
10 and 19 gallon heaters are not available in 3-phase.
PV 6495 10/07
Voltage Amps per kW
240, 1Ø 4.2
208, 3Ø 2.8
240, 3Ø 2.4
480, 3Ø 1.2
277, 1Ø 3.6
Model Prefix kW Input Gph recovery Number of elements and operation
22 4.5 22 Non-simultaneous operation of two 4.5 kW elements
30 6 30 Non-simultaneous operation of two 6 kW elements
44 9 44 Independent operation of two 4.5 kW elements
60 12 60 Independent operation of two 6 kW elements
*Available prefixes for 30 to 70 gallons models
/
